MP7614 查看數據表（PDF） - Exar Corporation
零件编号
产品描述 (功能)
生产厂家
MP7614 Datasheet PDF : 8 Pages
| |||
MP7614
ELECTRICAL CHARACTERISTICS (CONT’D)
NOTES:
1 Full Scale Range (FSR) is 10V for unipolar mode.
2 Guaranteed but not production tested.
3 Digital input levels should not go below ground or exceed the positive supply voltage, otherwise damage may occur.
4 Specified values guarantee functionality. Refer to other parameters for accuracy.
5 Linearity error is degraded by 65µV for every mV of voltage offset at output amplifier.
6 Output leakage current refers to IOUT1. 1 LSB of current constantly flows into IOUT2 (30nA at 5 kΩ input impedance, VREF = +10 V)
due to ladder termination into IOUT2.
Specifications are subject to change without notice
ABSOLUTE MAXIMUM RATINGS (TA = +25°C unless otherwise noted)1, 2
VDD to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0 to +17 V
Digital Input Voltage to GND . . . . GND –0.5 to VDD +0.5 V
IOUT1, IOUT2 to GND . . . . . . . . . . . GND –0.5 to VDD +0.5 V
VREF to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
VRFB to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +25 V
Storage Temperature . . . . . . . . . . . . . . . . . –65°C to +150°C
Lead Temperature (Soldering, 10 seconds) . . . . . . +300°C
Package Power Dissipation Rating to 75°C
CDIP, PDIP, SOIC . . . . . . . . . . . . . . . . . . . . . . . . . 900mW
Derates above 75°C . . . . . . . . . . . . . . . . . . . . . 12mW/°C
NOTES:
1 Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a
stress rating only and functional operation at or above this specification is not implied. Exposure to maximum rating
conditions for extended periods may affect device reliability.
2 Any input pin which can see a value outside the absolute maximum ratings should be protected by Schottky diode clamps
(HP5082-2835) from input pin to the supplies. All inputs have protection diodes which will protect the device from short
transients outside the supplies of less than 100mA for less than 100µs.
APPLICATION NOTES
Refer to Section 8 for Applications Information
Rev. 2.00
4
Share Link: 