MAX8561 查看數據表（PDF） - Maxim Integrated
零件编号
产品描述 (功能)
生产厂家
MAX8561 Datasheet PDF : 12 Pages
| |||
4MHz, 500mA Synchronous Step-Down
DC-DC Converters in Thin SOT and TDFN
INPUT
Li+ BATTERY
2.2µF
IN
LX
GND MAX8561
2.2µH
100kΩ
ON/OFF
1.5/1.0
SHDN
FB
120kΩ
ODO
ODI
PGND
220pF
150kΩ
OUTPUT
1.5V OR 1.0V
AT 500mA
2.2µF
INPUT
Li+ BATTERY
2.2µF
ON/OFF
HP/ LP
PFET
IN
ODO
LX
GND MAX8562
FB
SHDN
ODI
PGND
1.5µH
100kΩ
OUTPUT
1.2V OR VBATT
2.2µF
150pF
100kΩ HP = HIGH-POWER MODE
LP = LOW-POWER MODE
Figure 2. Using ODI/ODO to Obtain Two Output Voltages from
the MAX8561
Figure 3. Using the MAX8562 to Control an External Bypass
PFET for a Two-Step VCC in CDMA-PA Applications
Capacitor Selection
Output Capacitor
The output capacitor, COUT, is required to keep the
output voltage ripple small and to ensure regulation
loop stability. COUT must have low impedance at the
switching frequency. Ceramic capacitors with X5R or
X7R dielectrics are highly recommended due to their
small size, low ESR, and small temperature coefficients.
Due to the unique feedback network, the output capac-
itance can be very low. For most applications, a 2.2µF
capacitor is sufficient. For optimum load-transient per-
formance and very low output ripple, the output capaci-
tor value in µFs should be equal to or larger than the
inductor value in µHs.
Input Capacitor
The input capacitor, CIN, reduces the current peaks
drawn from the battery or input power source and
reduces switching noise in the IC. The impedance of
CIN at the switching frequency should be kept very low.
Ceramic capacitors with X5R or X7R dielectrics are
highly recommended due to their small size, low ESR,
and small temperature coefficients. Due to the
MAX8560/MAX8561/MAX8562s’ soft-start, the input
capacitance can be very low. For most applications, a
2.2µF capacitor is sufficient.
Feed-Forward Capacitor
The feed-forward capacitor, CFF, sets the feedback loop
response, controls the switching frequency, and is criti-
cal in obtaining the best efficiency possible. Choose a
small ceramic X7R capacitor with a value given by:
CFF
=
L ×10
R1
Siemens
Select the closest standard value to CFF as possible.
PC Board Layout and Routing
High switching frequencies and relatively large peak cur-
rents make the PC board layout a very important part of
design. Good design minimizes excessive EMI on the
feedback paths and voltage gradients in the ground
plane, both of which can result in instability or regulation
errors. Connect CIN close to IN and GND. Connect the
inductor and output capacitor as close to the IC as pos-
sible and keep their traces short, direct, and wide.
Connect GND and PGND separately to the ground
plane. The external feedback network should be very
close to the FB pin, within 0.2in (5mm). Keep noisy
traces, such as the LX node, as short as possible. For
the 8-pin TDFN package, connect GND to the exposed
paddle directly under the IC. Figure 4 illustrates an
example PC board layout and routing scheme.
8 _______________________________________________________________________________________
Share Link: 