STFPC311
3 Initialization
3.6.3
Watchdog timer operation during standby
● When a hot-key signal is detected either from the front panel or remote control during
standby, the STBY de-asserts.
● The de-assertion of the STBY triggers the watchdog timer.
● The timer value is the programmed value that is set by the user (1s-15s). If the user did not
change the value before entering standby, then it remains 10s.
● Also note: that The watchdog timer is off when the STFPC311 is in the standby mode to
save power.
Figure 5. Standby condition
3 a ) S ta n d b y C o n d itio n (N o rm a l b e h a vio r )
Hot key command from IR
or Key pad for wake up
W DG timer triggers
STBY
READY
MUTE
R E A D Y a sse rts w ith in p ro g ra m m e d tim e r va lu e (1 s-1 5 s)
3b ) S ta n d b y C o n d itio n ( A b n o rm a l b e h a vio r, p ro c e s s o r is n o t re s p o n d in g)
H ot key com m and from IR W DG timer
or Key pad for wake up
triggers
Signals STBY after
W DG count is over
STBY
READY
MUTE
READY continues to remain low
The watchdog timer is triggered by a de-assertion of the STBY signal or by the internal
Power-on Reset signal. It is not affected by the STB pin.
11/39