MF1SPLUS6001DA4/03 查看數據表（PDF） - NXP Semiconductors.

零件编号

产品描述 (功能)

生产厂家

MF1SPLUS6001DA4/03

Mainstream contactless smart card IC for fast and easy solution development

NXP Semiconductors. 

NXP Semiconductors

MF1SPLUSx0y1

Mainstream contactless smart card IC

There are three different versions of the PICC. The UID is programmed into a locked part

of the NV-memory which is reserved for the manufacturer:

• unique 7-byte serial number

• unique 4-byte serial number

• non-unique 4-byte serial number

Due to security and system requirements, these bytes are write-protected after being

programmed by the PICC manufacturer at production.

Remark: The programmed 4-byte NUID serial number is not globally unique which has to

be considered in the contactless system design. See Ref. 11 for further information

regarding handling of UIDs.

The customer must decide which UID length to use when ordering the product, see

Table 2 for ordering information.

During personalization, the PICC can be configured to support Random ID in security

level 3. The user can configure whether Random ID or fixed UID shall be used. According

to ISO/IEC 14443-3 (see Ref. 5), the first anticollision loop returns the Random Number

Tag 08h, the 3-byte Random Number and the BCC, if Random ID is used. The retrieval of

the UID in this case can be done using the Virtual Card Support Last command (see

Ref. 3) or by reading out block 0.

8.2.1 Backwards compatibility protocol

The backwards compatibility of this product, as used in security level 1 and security

level 2, runs on the same protocol layer as MIFARE Classic 1K and MIFARE Classic 4K.

The protocol is formed out of the following components:

• Frame definition: according to ISO/IEC 14443-3

• Bit encoding: according to ISO/IEC 14443-2

• Error code handling: handling is proprietary as error codes are formatted in half bytes.

• Command specification: commands are proprietary. Please use the specification as in

Ref. 1 and Ref. 2 and the additional commands which are only implemented in

MIFARE Plus as described in this document and in Ref. 3.

The following security levels can run on this protocol:

• Security Level 0

• Security Level 1

8.2.2 ISO/IEC 14443-4 Protocol

The ISO/IEC 14443-4 Protocol (also known as T=CL) is used in many processor cards.

This protocol is used for the MIFARE Plus with the following security levels:

• Security Level 0: all commands

• Security Level 1: only the security level switch and originality function.

• Security Level 3: all commands

MF1SPLUSX0Y1_SDS

Product short data sheet

PUBLIC

All information provided in this document is subject to legal disclaimers.

Rev. 3.2 — 21 February 2011

187032

© NXP B.V. 2011. All rights reserved.

7 of 17

Share Link: