100EL11 查看數據表（PDF） - Fairchild Semiconductor
零件编号
产品描述 (功能)
生产厂家
100EL11 Datasheet PDF : 5 Pages
| |||
Absolute Maximum Ratings(Note 1)
PECL Supply Voltage (VCC) VEE = 0V
NECL Supply Voltage (VEE) VCC = 0V
PECL DC Input Voltage (VI) VEE = 0V
NECL DC Input Voltage (VI) VCC = 0V
DC Output Current (IOUT)
Continuous
Surge
Storage Temperature (TSTG)
0.0V to +8.0V
0.0V to −8.0V
0.0V to +6.0V
0.0V to −6.0V
50 mA
100 mA
−65°C to +150°C
Recommended Operating
Conditions
PECL Power Supply
(VEE = 0V)
NECL Power Supply
VCC = 4.2V to 5.5V
(VCC = 0V)
VEE = −4.2V to −5.5V
Free Air Operating Temperature (TA)
−40°C to +85°C
Note 1: The “Absolute Maximum Ratings” are those values beyond which
the safety of the device cannot be guaranteed. The device should not be
operated at these limits. The parametric values defined in the Electrical
Characteristics tables are not guaranteed at the absolute maximum rating.
The “Recommended Operating Conditions” table will define the conditions
for actual device operation.
100EL PECL DC Electrical Characteristics VCC = 5.0V; VEE = 0.0V (Note 2)
Symbol
Parameter
−40°C
25°C
85°C
Units
Min Typ Max Min Typ Max Min Typ Max
IEE
VOH
VOL
VIH
VIL
VIHCMR
Power Supply Current
Output HIGH Voltage (Note 3)
Output LOW Voltage (Note 3)
Input HIGH Voltage (Single Ended)
Input LOW Voltage (Single Ended)
Input HIGH Voltage Common Mode
Range (Differential) (Note 4)
26
31
26
31
30
36
mA
3915 3995 4120 3975 4045 4120 3975 4050 4120 mV
3170 3305 3445 3190 3295 3380 3190 3295 3380 mV
3835
4120 3835
4120 3835
4120 mV
3190
3525 3190
3525 3190
3525 mV
2.5
4.6
2.5
4.6
2.5
4.6
V
IIH
Input HIGH Current (Note 5)
150
150
150
µA
IIL
Input LOW Current (Note 5)
0.5
0.5
0.5
µA
Note 2: Input and output parameters vary 1 to 1 with VCC. VEE can vary +0.8V/−0.5V.
Note 3: Outputs are terminated through a 50Ω Resistor to VCC − 2.0V.
Note 4: VIHCMR minimum varies 1 to 1 with VEE. VIHCMR maximum varies 1 to 1 with VCC. The VIHCMR range is referenced to the most positive side of the dif-
ferential input signal. Normal operation is obtained if the HIGH level falls within the specified range and the peak-to-peak voltage lies between VPPMIN and
1V.
Note 5: Absolute value of the input HIGH and LOW current should not exceed the absolute value of the stated MIn or Max specification.
Note: Devices are designed to meet the DC specifications after thermal equilibrium has been established. Circuit is tested with air flow greater than
500LFPM maintained.
www.fairchildsemi.com
2
Share Link: 