M27W201-200K6TR 查看數據表（PDF） - STMicroelectronics
零件编号
产品描述 (功能)
生产厂家
M27W201-200K6TR Datasheet PDF : 24 Pages
| |||
M27W201
Device Description
2.3
Two-line output control
Because EPROMs are usually used in larger memory arrays, this product features a 2-line
control function which accommodates the use of multiple memory connection. The two line
control function allows:
● the lowest possible memory power dissipation,
● complete assurance that output bus contention will not occur.
For the most efficient use of these two control lines, E should be decoded and used as the
primary device selecting function, while G should be made a common connection to all
devices in the array and connected to the READ line from the system control bus. This
ensures that all deselected memory devices are in their low power standby mode and that
the output pins are only active when data is required from a particular memory device.
2.4
System considerations
The power switching characteristics of Advanced CMOS EPROMs require careful
decoupling of the devices. The supply current, ICC, has three segments that are of interest to
the system designer: the standby current level, the active current level, and transient current
peaks that are produced by the falling and rising edges of E. The magnitude of the transient
current peaks is dependent on the capacitive and inductive loading of the device at the
output.
The associated transient voltage peaks can be suppressed by complying with the two line
output control and by properly selected decoupling capacitors. It is recommended that a
0.1µF ceramic capacitor be used on every device between VCC and VSS. This should be a
high frequency capacitor of low inherent inductance and should be placed as close to the
device as possible. In addition, a 4.7µF bulk electrolytic capacitor should be used between
VCC and VSS for every eight devices. The bulk capacitor should be located near the power
supply connection point. The purpose of the bulk capacitor is to overcome the voltage drop
caused by the inductive effects of PCB traces.
2.5
Programming
The M27W201 has been designed to be fully compatible with the M27C2001 and has the
same electronic signature. As a result the M27W201 can be programmed as the M27C2001
on the same programming equipment applying 12.75V on VPP and 6.25V on VCC by the use
of the same PRESTO II algorithm.
When delivered (and after each ‘1’s erasure for UV EPROM), all bits of the M27W201 are in
the '1' state.Data is introduced by selectively programming '0's into the desired bit locations.
Although only '0's will be programmed, both '1's and '0's can be present in the data word.
The only way to change a ‘0’ to a ‘1’ is by die exposure to ultraviolet light (UV EPROM). The
M27W201 is in the programming mode when VPP input is at 12.75V, E is at VIL and P is
pulsed to VIL. The data to be programmed is applied to 8 bits in parallel to the data output
pins. The levels required for the address and data inputs are TTL. VCC is specified to be
6.25V ± 0.25V.
9/24
Share Link: 