25AA160A 查看數據表（PDF） - Microchip Technology

零件编号

产品描述 (功能)

生产厂家

25AA160A

16K SPI Bus Serial EEPROM

Microchip Technology 

25XX160A/B

2.5 Read Status Register Instruction

(RDSR)

The Read Status Register instruction (RDSR) provides

access to the Status Register. The Status Register may

be read at any time, even during a write cycle. The

Status Register is formatted as follows:

TABLE 2-2: STATUS REGISTER

7

654 3

2

1

0

W/R – – – W/R W/R R

R

WPEN X X X BP1 BP0 WEL WIP

W/R = writable/readable. R = read-only.

The Write-In-Process (WIP) bit indicates whether the

25XX160A/B is busy with a write operation. When set

to a ‘1’, a write is in progress, when set to a ‘0’, no write

is in progress. This bit is read-only.

The Write Enable Latch (WEL) bit indicates the status

of the write enable latch and is read-only. When set to

a ‘1’, the latch allows writes to the array, when set to a

‘0’, the latch prohibits writes to the array. The state of

this bit can always be updated via the WREN or WRDI

commands regardless of the state of write protection

on the Status Register. These commands are shown in

Figure 2-4 and Figure 2-5.

The Block Protection (BP0 and BP1) bits indicate

which blocks are currently write-protected. These bits

are set by the user issuing the WRSR instruction. These

bits are nonvolatile, and are shown in Table 2-3.

See Figure 2-6 for the RDSR timing sequence.

FIGURE 2-6: READ STATUS REGISTER TIMING SEQUENCE (RDSR)

CS

SCK

SI

SO

0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

instruction

0 00 00 1 01

high-impedance

data from Status Register

7 6 54 3 2 10

DS21807B-page 10

 2003 Microchip Technology Inc.

Share Link: