73S8023C 查看數據表（PDF） - Teridian Semiconductor Corporation

零件编号

产品描述 (功能)

生产厂家

73S8023C

Smart Card Interface

Teridian Semiconductor Corporation 

DS_8023C_019

73S8023C Data Sheet

2 System Controller Interface

• The CS (chip select) input allows multiple devices to operate in parallel. When CS is high, the system

interface signals operate as described. When CS is taken low, the system interface signals are

latched internally. The pins I/OUC, AUX1UC, and AUX2UC are weakly pulled up and the OFF signal

is put into a high impedance state.

• The CLKSEL signal selects between synchronous and asynchronous operation. When CLKSEL is

low, asynchronous operation is selected. When CLKSEL is high, synchronous operation is selected.

• Digital inputs allow direct control of the card interface from the host as follows:

 Pin CMDVCC: When set low, starts an activation sequence if a card is present.

 Pin 5V/#V: Defines the card voltage.

• The card I/O and Reset signals have their corresponding controller I/Os to be connected directly to

the host:

 Pin RSTIN: controls the card RST signal. When enabled by the sequencer, RST is equal to

RSTIN for both synchronous and asynchronous modes.

 Pin I/OUC: data transfer to card I/O contact.

 Pins AUX1UC and AUX2UC (auxiliary I/O lines associated to the auxiliary I/Os which are

connected to the C4 and C8 card connector contacts).

• Two digital inputs control the card clock frequency division rate: CLKDIV1 and CLKDIV2 define the

card clock frequency from the input clock frequency (crystal or external clock). The division rate is

defined as follows:

CLKDIV2

0

0

1

1

CLKDIV1

0

1

0

1

CLK

⅛ XTAL

XTAL

¼ XTAL

½ XTAL

When the division rate is equal to 1 (CLKDIV2 =0 and CLKDIV1 = 1), the duty-cycle of the

card clock depends on the duty-cycle and waveform of the signal applied on the pin XTALIN.

When other division rates are used, the 73S8023C circuitry guarantees a duty-cycle in the

range 45% to 55%, conforming to ISO-7816-3 and EMV 4.1 specifications.

• Interrupt output to the host: As long as the card is not activated, the OFF pin informs the host about

the card presence only (low = no card in the reader). When CMDVCC is set low (Card activation

sequence requested from the host), a low level on OFF means a fault has been detected (e.g. card

removedl during a card session, or voltage fault, or thermal / over-current fault) that automatically

initiates a deactivation sequence.

• Power Down: The PWRDN pin is a digital input that allows the host controller to put the 73S8023C in

its Power Down state. This pin can only be activated outside of a card session.

• The CLKOUT signal is a buffered output of the signal applied to the XTALIN pin whether it is an

external clock source or it is configured as a crystal oscillator. CLKOUT can be used when using

multiple 73S8023C devices to share a single clock signal.

• The STROBE input directly drives the smart card CLK signal when operating in synchronous mode.

STROBE is ignored in asynchronous mode.

Rev. 1.5

7

Share Link: