DMF5005NF-LY 查看數據表（PDF） - Optrex Corporation
零件编号
产品描述 (功能)
生产厂家
DMF5005NF-LY Datasheet PDF : 17 Pages
| |||
3.Optical Specifications
3.1. LCD Driving Voltage
Parameter
Symbol
Conditions
Min.
Typ. Max. Units
Recommended
Ta= 0°C
-
-
15.6
V
LCD Driving Voltage
VCC-VEE
Ta=25°C
12.4 13.3 14.2
V
Note 1
Ta=50°C
11.2
-
-
V
Note 1 : Voltage (Applied actual waveform to LCD Module) for the best contrast. The range of
minimum and maximum shows tolerance of the operating voltage. The specified contrast
ratio and response time are not guaranteed over the entire range.
3.2.Optical Characteristics
Ta=25°C, 1/64 Duty, 1/9 Bias, VD=13.3V (Note 4), θ= 0°, φ= - °
Parameter
Symbol
Conditions
Min.
Typ. Max. Units
Contrast Ratio Note 1
CR
θ= 0°, φ= - °
-
7
-
Viewing Angle
Shown in 3.3
Response Rise Note 2
TON
-
-
70
140
ms
Time Decay Note 3 TOFF
-
-
330
500
ms
Note 1 :Contrast ratio is definded as follows.
CR = LOFF / LON
LON : Luminance of the ON segments
LOFF : Luminance of the OFF segments
Note 2 :The time that the luminance level reaches 90% of the saturation level from 0% when
ON signal is applied.
Note 3 :The time that the luminance level reaches 10% of the saturation level from 100% when
OFF signal is applied.
Note 4 :Definition of Driving Voltage VD
Assuming that the typical driving waveforms shown below are applied to the LCD Panel
at 1/A Duty - 1/B Bias ( A : Duty Number, B : Bias Number ). Driving voltage VD is
definded as follows.
VD = (Vth1+Vth2) / 2
Vth1 : The voltage VO-P that should provide 50% of the saturation level in the luminance
at the segment which the ON signal is applied to.
Vth2 : The voltage VO-P that should provide 50% of the saturation level in the luminance
at the segment which the OFF signal is applied to.
VO-P
1 / ( fF ×A )
<ON SIGNAL>
DMF5005NF-SEW-BBE-CQ (CQ) No. 2001-0149
1 / fF
( B-2 )× VO-P / B
<OFF SIGNAL>
OPTREX CORPORATION
Page 7/17
Share Link: 