EVAL-AD7858CB 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

生产厂家

EVAL-AD7858CB

3 V to 5 V Single Supply, 200 kSPS 8-Channel, 12-Bit Sampling ADC

Analog Devices 

AD7858/AD7858L

CONTROL REGISTER

The arrangement of the Control Register is shown below. The control register is a write only register and contains 14 bits of data.

The control register is selected by putting two 1s in ADDR1 and ADDR0. The function of the bits in the control register are de-

scribed below. The power-up status of all bits is 0.

MSB

SGL/DIFF

CH2

CH1

CH0

PMGT1

PMGT0

RDSLT1

RDSLT0 2/3 MODE

CONVST CALMD CALSLT1 CALSLT0

STCAL

LSB

Bit Mnemonic

13 SGL/DIFF

12 CH2

11 CH1

10 CH0

9 PMGT1

8 PMGT0

7 RDSLT1

6 RDSLT0

5 2/3 MODE

4 CONVST

3 CALMD

2 CALSLT1

1 CALSLT0

0 STCAL

CONTROL REGISTER BIT FUNCTION DESCRIPTION

Comment

A 0 in this bit position configures the input channels in pseudo-differential mode. A 1 in this bit position

configures the input channels in single-ended mode (see Table III).

These three bits are used to select the channel on which the conversion is performed. The channels can

be configured as eight single-ended channels or four pseudo-differential channels. The default selection

is AIN1 for the positive input and AIN2 for the negative input (see Table III for channel selection).

Power Management Bits. These two bits are used with the SLEEP pin for putting the part into various

Power-Down Modes (see Power-Down section for more details).

Theses two bits determine which register is addressed for the read operations (see Table II).

Interface Mode Select Bit. With this bit set to 0, Interface Mode 2 is enabled. With this bit set to 1,

Interface Mode 1 is enabled where DIN is used as an output as well as an input. This bit is set to 0 by

default after every read cycle; thus when using the Two-Wire Interface Mode, this bit needs to be set to

1 in every write cycle.

Conversion Start Bit. A logic one in this bit position starts a single conversion, and this bit is automati-

cally reset to 0 at the end of conversion. This bit may also be used in conjunction with system calibration

(see Calibration section.)

Calibration Mode Bit. A 0 here selects self-calibration, and a 1 selects a system calibration (see Table IV).

Calibration Selection Bits and Start Calibration Bit. These bits have two functions.

With the STCAL bit set to 1 the CALSLT1 and CALSLT0 bits determine the type of calibration per

formed by the part (see Table IV). The STCAL bit is automatically reset to 0 at the end of calibration.

With the STCAL bit set to 0 the CALSLT1 and CALSLT0 bits are decoded to address the calibration

register for read/write of calibration coefficients (see section on the Calibration Registers for more details).

–10–

REV. B

Share Link: