AD7843ARU(Rev0) 查看數據表（PDF） - Analog Devices

零件编号

产品描述 (功能)

生产厂家

AD7843ARU
(Rev.:Rev0)

Touch Screen Digitizer

Analog Devices 

AD7843

ANALOG INPUT

Figure 4 shows an equivalent circuit of the analog input struc-

ture of the AD7843 which contains a block diagram of the input

multiplexer, the differential input of the A/D converter and the

differential reference.

Table I shows the multiplexer address corresponding to each

analog input, both for the SER/DFR bit in the control register

set high and low. The control bits are provided serially to the

device via the DIN pin. For more information on the control

register see the Control Register section.

When the converter enters the hold mode, the voltage difference

between the +IN and –IN inputs (see Figure 4) is captured on

the internal capacitor array. The input current on the analog

inputs depends on the conversion rate of the device. During the

sample period, the source must charge the internal sampling

capacitor (typically 37 pF). Once the capacitor has been fully

charged, there is no further input current. The rate of charge

transfer from the analog source to the converter is a function of

conversion rate.

Acquisition Time

The track and hold amplifier enters its tracking mode on the

falling edge of the fifth DCLK after the START bit has been

detected (see Figure 13). The time required for the track and

hold amplifier to acquire an input signal will depend how

quickly the 37 pF input capacitance is charged. With zero

source impedance on the analog input three DCLK cycles will

always be sufficient to acquire the signal to the 12-bit level.

With a source impedance RIN on the analog input, the actual

acquisition time required is calculated using the formula:

tACQ = 8.4 × (RIN +100 Ω) × 37 pF

where RIN is the source impedance of the input signal, and

100 Ω, 37 pF is the input RC value. Depending on the frequency

of DCLK used, three DCLK cycles may or may not be suffi-

cient to acquire the analog input signal with various source

impedance values.

VCC

X+

X–

Y+

Y–

REF

X+ Y+ EXT

ON-CHIP SWITCHES

X+

Y+

4-TO-1

IN3

MUX

IN4

3-TO-1

MUX

IN+

REF+

IN+ ADC CORE

IN– REF–

3-TO-1

MUX

DATA OUT

X– Y– GND

Figure 4. Equivalent Analog Input Circuit

REV. 0

–9–

Share Link: