AD846 查看數據表（PDF） - Analog Devices
零件编号
产品描述 (功能)
生产厂家
AD846 Datasheet PDF : 12 Pages
| |||
Figure 39. AD846 Three-Terminal Model
AD846
A simple equation can, therefore, be used to determine the band-
width of an amplifier employing the AD846 in the inverting
configuration.
( ) 3 dB Bandwidth =
23
RF + 0.05 1 + G
where: The 3 dB bandwidth is in MHz
G is the closed-loop inverting gain of the AD846
RF is the feedback resistance in kΩ.
NOTE: This equation applies only for values of RF between
10 kΩ and 100 kΩ, and for RLOAD greater than 500 Ω. For RF =
1 kΩ the bandwidth should be estimated from Figure 41.
Figure 41 illustrates the closed-loop voltage gain vs. frequency
of the AD846 for various values of feedback resistor. For com-
parison purposes, the characteristic of a conventional amplifier
having an 80 MHz unity gain bandwidth is also shown.
Figure 40. Op Amp Three-Terminal Model
A more detailed examination of the closed-loop transfer func-
tion of the AD846 results in the following equation:
− RF
RS
Closed-Loop Gain G(s) =
1 +
CCOMP
RF
+
1+
RF
RS
RIN
s
Compare this to the equation for a conventional op amp:
− RF
RS
Closed-Loop Gain G(s) =
1 +
CCOMP
gM
1+
RF
RS
s
where: CCOMP is the internal compensation capacitor of the am-
plifier; gM is the input stage transconductance of the amplifier.
In the case of the voltage amplifier, the closed-loop bandwidth
decreases directly with increasing values of (1 + RF/RS), the
closed-loop gain. However, for the transimpedance amplifier,
the situation is different. At low gains, where (1 + RF/RS) RIN is
small compared to RF, the closed-loop bandwidth is controlled
by the internal compensation capacitance of 7 pF and the value
of RF, and not by the closed-loop gain. At higher gains, where (1
+ RF/RS) RIN is much larger than RF, the behavior is that of a con-
ventional operational amplifier in which the input stage transcon-
ductance is equal to the inverting terminal input impedance of
the transimpedance amplifier (RIN = 50 Ω).
Figure 41. Closed-Loop Voltage Gain vs. Bandwidth for
Various Values of RF
For the case where RF = 1 kΩ and RS = 100 Ω (closed-loop gain
of –10), the closed-loop bandwidth is approximately 28 MHz. It
should also be noted that the use of a capacitor to shunt RF, a
normal practice for stabilizing conventional op amps, will cause
this amplifier to become unstable because the closed-loop band-
width will increase beyond the stable operating frequency.
A similar approach can be taken to calculate the noise perfor-
mance of the amplifier. A simplified noise model is shown in
Figure 42.
The equivalent mean-square output noise voltage spectral den-
sity will equal:
( ) ( ) VON 2 =
RF INN
2
+
1+
RF
RS
2
[VN 2
+
RP INP
2 + 4 kT RP ]
+
4
kT
RF
RF
RS
+ 1
REV. C
–9–
Share Link: 