ECP200G 查看數據表（PDF） - WJ Communications => Triquint
零件编号
产品描述 (功能)
生产厂家
ECP200G Datasheet PDF : 9 Pages
| |||
AH312 / ECP200G
2 Watt, High Linearity InGaP HBT Amplifier Product Information
ECP200G (SOIC-8 Package) Mechanical Information
This package may contain lead-bearing materials. The plating material on the leads is SnPb.
Outline Drawing
Product Marking
The component will be marked with an
“ECP200G” designator with an alphanumeric lot
code on the top surface of the package.
Tape and reel specifications for this part are
located on the website in the “Application
Notes” section.
ESD / MSL Information
Land Pattern
ESD Rating:
Value:
Test:
Standard:
Class 1B
Passes between 500 and 1000V
Human Body Model (HBM)
JEDEC Standard JESD22-A114
MSL Rating: Level 3 at +235° C convection reflow
Standard: JEDEC Standard J-STD-020
Mounting Config. Notes
1. A heatsink underneath the area of the PCB for the mounted device
is strictly required for proper thermal operation. Damage to the
device can occur without the use of one.
2. Ground / thermal vias are critical for the proper performance of this
device. Vias should use a .35mm (#80 / .0135”) diameter drill and
have a final plated thru diameter of .25 mm (.010”).
3. Add as much copper as possible to inner and outer layers near the
part to ensure optimal thermal performance.
4. Mounting screws can be added near the part to fasten the board to a
heatsink. Ensure that the ground / thermal via region contacts the
heatsink.
5. Do not put solder mask on the backside of the PC board in the
region where the board contacts the heatsink.
6. RF trace width depends upon the PC board material and
construction.
7. Use 1 oz. Copper minimum.
8. All dimensions are in millimeters (inches). Angles are in degrees.
Thermal Specifications
Parameter
Rating
Operating Case Temperature
-40 to +85° C
Thermal Resistance, Rth (1)
17.5° C / W
Junction Temperature, Tjc (2)
155° C
Notes:
1. The thermal resistance is referenced from the junction-
to-case at a case temperature of 85° C. Tjc is a
function of the voltage at pins 6 and 7 and the current
applied to pins 6, 7, and 8 and can be calculated by:
Tjc = Tcase + Rth * Vcc * Icc
2. This corresponds to the typical biasing condition of
+5V, 800 mA at an 85° C case temperature. A
minimum MTTF of 1 million hours is achieved for
junction temperatures below 247° C.
MTTF vs. GND Tab Temperature
100000
10000
1000
100
60
70 80 90 100 110 120
Tab Temperature (°C)
Specifications and information are subject to change without notice.
WJ Communications, Inc • Phone 1-800-WJ1-4401 • FAX: 408-577-6621 • e-mail: sales@wj.com • Web site: www.wj.com
Page 9 of 9 June 2005
Share Link: 