AIC1555 查看數據表（PDF） - Analog Intergrations
零件编号
产品描述 (功能)
生产厂家
AIC1555 Datasheet PDF : 15 Pages
| |||
AIC1555
APPLICATION INFORMATIONS
Introduction
AIC1555 is a low-noise, pulse-width-modulated
(PWM), DC-DC step-down converter. It features
an internal synchronous rectifier, which eliminates
external Schottky diode. AIC1555 is suitable for Li-
lon battery applications, or can be used at 3V or
5V fixed input voltage. It operates in one of
following four modes.
(1) Forced PWM mode operates at a fixed
frequency regardless of the load.
(2) Synchronizable PWM mode allows the
synchronization by using an external
switching frequency with a minimum
harmonics.
(3) PWM/PFM Mode extends battery life by
switching to a PFM pulse-skipping mode
under light loads.
(4) Shutdown mode sets device to standby,
reducing supply current to 0.1µA or under.
Continuous output current of AIC1555 can be
upward to 700mA and output voltage can be
adjusted from 0.75V to VIN with an input range
from 2.5V to 6.5V by a voltage divider. AIC1555
also features high efficiency, low dropout voltage,
and a 0.75V reference with ±2.5% accuracy. It is
available in a space-saving 8-pin MSOP package.
Operation
When power on, control logic block detects
SYNC/MODE pin connecting to VIN or GND to
determine operation function and gives a signal to
PWM/PFM control block to determine the proper
comparator (ref. Block Diagram). AIC1555 works
－ with an internal synchronous rectifier Q3, to
increase efficiency. When control logic block turns
Q2 on, Q3 will turn off through anti-short-through
block. Similarly, when Q3 is on, Q2 will turn off.
AIC1555 provides current limit function by using a
5Ω resistor. When Q1 turns on, current follows
through the 5Ω resistor. And current amplifier
senses the voltage, which crosses the resistor,
and amplifies it. When the sensed voltage gets
bigger than reference voltage, output current will
be clamped a maximum level.
AIC1555 provides the thermal protection. When
the action is happened then the control logic shuts
the device off.
PWM/PFM Function
When connecting SYNC/MODE pin to VIN, the
device is forced into PWM (Pulse-Width-
Modulated) mode with constant frequency.
Advantage of constant frequency is easily
reducing noise without complex post-filter. But its
disadvantage is low efficiency at light loading.
Therefore, AIC1555 provides a function to solve
this problem. When connecting SYNC/MODE pin
to GND, device is able to get into PWM/PFM
(Pulse-Frequency-Modulated) modes. Under a
light loading condition, the device turns to PFM
mode, which results in a higher efficiency. PWM
mode is on when heavy loading applies and the
noise is reduced.
Frequency Synchronization
Connecting an external clock signal to
SNYC/MODE pin can control switching frequency.
The acceptable range is from 500kHz to 1MHz.
This mode exhibits low output ripple as well as low
audio noise and reduces RF interference while
providing reasonable low current efficiency.
10
Share Link: 