AN249 查看數據表（PDF） - Silicon Laboratories

零件编号

产品描述 (功能)

生产厂家

AN249

HUMAN INTERFACE DEVICE TUTORIAL

Silicon Laboratories 

AN249

3. HID Specification Overview

The HID class of the universal serial bus (USB) protocol was created to define devices that interact to some degree

with humans and transfer data with a computer system.

3.1. Universal Serial Bus

USB protocol presents significant advantages over other PC interfaces in versatility, speed, and reliability. USB

systems communicate under device/host relationships where a device is attached to a USB port of a host PC or a

hub that is then connected to a PC. Host-side application software interacts with device-side firmware through the

native operating system or customized drivers.

3.1.1. Device Endpoints

In USB-based systems, all data travels to or from device endpoints. The USB specification requires that all devices

have a control endpoint. The host uses this endpoint to retrieve information about the device through data packets

called descriptors. Many USB devices also support additional endpoints that transfer data to and from the host. IN

endpoints transfer data from the device to the host while OUT endpoints transfer data from the host to the device.

3.1.2. Silicon Laboratories Microcontroller Capabilities

Silicon Laboratories microcontroller families with USB functionality can support a control endpoint and at least one

additional endpoint. USB hardware controls low-level data transfer to and from the host. The hardware sends and

receives data through user-accessible buffers. The microcontroller signals firmware about USB events, including

data reception and transmission-related events, by setting flags. These flags trigger the servicing of an interrupt

service routine (ISR) if interrupts have been enabled.

3.1.3. USB Device Classes

The USB specification and supplemental documents define a number of device classes that categorize USB

devices according to capability and interface requirements. When a host retrieves device information, class

classification helps the host to determine how to communicate with the USB device.

3.2. Human Interface Device Class

The HID class devices usually interface with humans in some capacity. HID-class devices include mice, keyboards,

printers, etc. However, the HID specification merely defines basic requirements for devices and the protocol for

data transfer, and devices do not necessarily depend on any direct human interaction.

3.2.1. Class Requirements

HID devices must meet a few general requirements that are imposed to keep the HID interface standardized and

efficient:

All HID devices must have a control endpoint (Endpoint 0) and an interrupt IN endpoint. Many devices also use

an interrupt OUT endpoint. In most cases, HID devices are not allowed to have more than one OUT and one IN

endpoint.

All data transferred must be formatted as reports whose structure is defined in the report descriptor. Reports are

discussed in detail later in this document.

HID devices must respond to standard HID requests in addition to all standard USB requests.

4

Rev. 0.2

Share Link: