AS1108 查看數據表（PDF） - austriamicrosystems AG

零件编号

产品描述 (功能)

生产厂家

AS1108

4-Digit LED Display Driver

austriamicrosystems AG 

AS1108

Data Sheet

9 Pinout and Packaging

Pin Assignments

Figure 12. DIP and SO Pin Assignments (Top View)

DOUT 1

20 SEG D

DIN 2

19 SEG DP

DIG 0 3

18 SEG E

GND 4

17 SEG C

DIG 2 5 AS1108 16 VDD

DIG 3 6

15 ISET

GND 7

14 SEG G

DIG 1 8

13 SEG B

LOAD/CSN 9

12 SEG F

CLK 10

11 SEG A

austriamicrosystems

Pin Assignments

Pin Descriptions

Table 24. Pin Descriptions

Pin

Name

DOUT

DIN

DIG 0:DIG 3

GND

LOAD/CSN

CLK

SEG A:SEG G, SEG DP

ISET

VDD

Pin

Number

Description

Serial-Data Output. The data into pin DIN is valid at pin DOUT 16.5 clock

1

cycles later. This pin is used to daisy-chain several AS1108 devices and is

never high-impedance.

2

Serial-Data Input. Data is loaded into the internal 16-bit shift register on the

rising edge of pin CLK.

Digit Drive Lines. 4 four-digit drive lines that sink current from the display

3, 5, 6, 8 common cathode. The AS1108 pulls the digit outputs to VDD when turned

off.

4, 7 Ground. Both GND pins must be connected.

Load-Data Input. The last 16 bits of serial data are latched on the rising

edge of this pin.

9

Chip-Select Input (AS1108 SPI-enabled only). Serial data is loaded into the

shift register while this pin is low. The last 16 bits of serial data are latched

on the rising edge of this pin.

Serial-Clock Input. 10MHz maximum rate. Data is shifted into the internal

10

shift register on the rising edge of this pin. Data is clocked out of DOUT on

the falling edge of this pin. On the AS1108 SPI-enabled, the CLK input is

active only while pin LOAD/CSN is low.

11, 12, 13, Seven Segment and Decimal Point Drive Lines. 8 seven-segment drives

14, 17, 18, and decimal point drive that source current to the display. When a segment

19, 20 driver is turned off it is pulled to GND.

Set Segment Current. Connect to VDD through RSET to set the peak

15

segment current (see Selecting RSET Resistor Value and Using External

Drivers on page 12).

16

Positive Supply Voltage. Connect to +2.7 to +5.5V supply.

www.austriamicrosystems.com

Revision 2.1

15 - 19

Share Link: