24C32C 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

24C32C

2-Wire Serial EEPROM

Atmel Corporation 

AT24C32C/64C

2. Pin Description

SERIAL CLOCK (SCL): The SCL input is used to positive edge clock data into each EEPROM

device and negative edge clock data out of each device.

SERIAL DATA (SDA): The SDA pin is bidirectional for serial data transfer. This pin is open-drain

driven and may be wire-ORed with any number of other open-drain or open collector devices.

DEVICE/ADDRESSES (A2, A1, A0): The A2, A1 and A0 pins are device address inputs that are

hard wired or left not connected for hardware compatibility with other AT24CXX devices. When

the pins are hardwired, as many as eight 32K/64K devices may be addressed on a single bus

system (device addressing is discussed in detail under the Device Addressing section). If the

pins are left floating, the A2, A1 and A0 pins will be internally pulled down to GND if the capaci-

tive coupling to the circuit board VCC plane is <3pF. If coupling is >3pF, Atmel® recommends

connecting the address pins to GND.

WRITE PROTECT (WP): The write protect input, when connected to GND, allows normal write

operations. When WP is connected high to VCC, all write operations to the memory are inhibited.

If the pin is left floating, the WP pin will be internally pulled down to GND if the capacitive cou-

pling to the circuit board VCC plane is <3pF. If coupling is >3pF, Atmel recommends connecting

the pin to GND.

3

5298A–SEEPR–1/08

Share Link: