28F016C3 查看數據表（PDF） - Intel
零件编号
产品描述 (功能)
生产厂家
28F016C3 Datasheet PDF : 59 Pages
| |||
E
3 VOLT ADVANCED+ BOOT BLOCK
4.0 ABSOLUTE MAXIMUM
RATINGS*
Extended Operating Temperature
During Read .......................... –40 °C to +85 °C
During Block Erase
and Program.......................... –40 °C to +85 °C
Temperature Under Bias ....... –40 °C to +85 °C
Storage Temperature................. –65 °C to +125 °C
Voltage on Any Pin
(except VCC and VPP)
with Respect to GND ............. –0.5 V to +5.0 V1
VPP Voltage (for Block
Erase and Program)
with Respect to GND .......–0.5 V to +13.5 V1,2,4
VCC and VCCQ Supply Voltage
with Respect to GND ............. –0.2 V to +5.0 V1
Output Short Circuit Current...................... 100 mA3
4.2 Operating Conditions
NOTICE: This datasheet contains preliminary information on
products in the design phase of development. The
specifications are subject to change without notice. Verify
with your local Intel Sales office that you have the latest
datasheet before finalizing a design.
* WARNING: Stressing the device beyond the "Absolute
Maximum Ratings" may cause permanent damage. These
are stress ratings only. Operation beyond the "Operating
Conditions" is not recommended and extended exposure
beyond the "Operating Conditions" may effect device
reliability.
NOTES:
1. Minimum DC voltage is –0.5 V on input/output pins.
During transitions, this level may undershoot to –2.0 V
for periods < 20 ns. Maximum DC voltage on
input/output pins is VCC + 0.5 V which, during
transitions, may overshoot to VCC + 2.0 V for periods
< 20 ns.
2. Maximum DC voltage on VPP may overshoot to +14.0 V
for periods < 20 ns.
3. Output shorted for no more than one second. No more
than one output shorted at a time.
4. VPP voltage is normally 1.65 V–3.6 V. Connection to
supply of 11.4 V–12.6 V can only be done for 1000
cycles on the main blocks and 2500 cycles on the
parameter blocks during program/erase. VPP may be
connected to 12 V for a total of 80 hours maximum.
See Section 3.5 for details.
Table 10. Temperature and Voltage Operating Conditions
Symbol
Parameter
Notes
Min
Max
Units
TA
VCC1
VCC2
VCCQ1
VPP1
Operating Temperature
VCC Supply Voltage
I/O Supply Voltage
Supply Voltage
–40
+85
°C
1
2.7
3.6
Volts
1
3.0
3.6
1
2.7
3.6
Volts
1
1.65
3.6
Volts
VPP2
1, 2
11.4
12.6
Volts
Cycling
Block Erase Cycling
2
100,000
Cycles
NOTES:
1. VCC and VCCQ must share the same supply when they are in the VCC1 range.
2. Applying VPP = 11.4 V–12.6 V during a program/erase can only be done for a maximum of 1000 cycles on the main blocks
and 2500 cycles on the parameter blocks. VPP may be connected to 12 V for a total of 80 hours maximum. See Section
3.5 for details.
PRODUCT PREVIEW
25
Share Link: 