ATMEGA64A-MNR(2013) 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

ATMEGA64A-MNR
(Rev.:2013)

8-bit Atmel Microcontroller with 64KB In-System Programmable Flash

Atmel Corporation 

• Boot Loader capabilities is not supported.

• It is not possible to adjust the frequency of the internal calibrated RC Oscillator.

• The External Memory Interface can not release any Address pins for general I/O, neither configure different wait

states to different External Memory Address sections.

• Only EXTRF and PORF exist in the MCUCSR Register.

• No timed sequence is required for Watchdog Timeout change.

• Only low-level external interrupts can be used on four of the eight External Interrupt sources.

• Port C is output only.

• USART has no FIFO buffer, so Data OverRun comes earlier.

• The user must have set unused I/O bits to 0 in ATmega103 programs.

2.3 Pin Descriptions

2.3.1 VCC

Digital supply voltage.

2.3.2 GND

Ground.

2.3.3

Port A (PA7:PA0)

Port A is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port A output buf-

fers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port A pins that are

externally pulled low will source current if the pull-up resistors are activated. The Port A pins are tri-stated when a

reset condition becomes active, even if the clock is not running.

Port A also serves the functions of various special features of the ATmega64A as listed on page 72.

2.3.4

Port B (PB7:PB0)

Port B is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port B output buf-

fers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port B pins that are

externally pulled low will source current if the pull-up resistors are activated. The Port B pins are tri-stated when a

reset condition becomes active, even if the clock is not running.

Port B also serves the functions of various special features of the ATmega64A as listed on page 73.

2.3.5

Port C (PC7:PC0)

Port C is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port C output buf-

fers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port C pins that are

externally pulled low will source current if the pull-up resistors are activated. The Port C pins are tri-stated when a

reset condition becomes active, even if the clock is not running.

Port C also serves the functions of special features of the ATmega64A as listed on page 76. In ATmega103 com-

patibility mode, Port C is output only, and the port C pins are not tri-stated when a reset condition becomes active.

2.3.6

Port D (PD7:PD0)

Port D is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port D output buf-

fers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port D pins that are

externally pulled low will source current if the pull-up resistors are activated. The Port D pins are tri-stated when a

reset condition becomes active, even if the clock is not running.

Port D also serves the functions of various special features of the ATmega64A as listed on page 77.

ATmega64A [DATASHEET]

5

8160D–AVR–02/2013

Share Link: