ATTINY13-12SJ 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

ATTINY13-12SJ

8-bit Microcontroller with 1K Bytes In-System Programmable Flash

Atmel Corporation 

I/O Memory

ATtiny13

The I/O space definition of the ATtiny13 is shown in “Register Summary” on page 153.

All ATtiny13 I/Os and peripherals are placed in the I/O space. All I/O locations may be

accessed by the LD/LDS/LDD and ST/STS/STD instructions, transferring data between

the 32 general purpose working registers and the I/O space. I/O Registers within the

address range 0x00 - 0x1F are directly bit-accessible using the SBI and CBI instruc-

tions. In these registers, the value of single bits can be checked by using the SBIS and

SBIC instructions. Refer to the instruction set section for more details. When using the

I/O specific commands IN and OUT, the I/O addresses 0x00 - 0x3F must be used.

When addressing I/O Registers as data space using LD and ST instructions, 0x20 must

be added to these addresses.

For compatibility with future devices, reserved bits should be written to zero if accessed.

Reserved I/O memory addresses should never be written.

Some of the Status Flags are cleared by writing a logical one to them. Note that, unlike

most other AVRs, the CBI and SBI instructions will only operate on the specified bit, and

can therefore be used on registers containing such Status Flags. The CBI and SBI

instructions work with registers 0x00 to 0x1F only.

The I/O and Peripherals Control Registers are explained in later sections.

19

2535B–AVR–01/04

Share Link: