ATTINY461A 查看數據表（PDF） - Atmel Corporation

零件编号

产品描述 (功能)

生产厂家

ATTINY461A

8-bit Microcontroller with 2/4/8K Bytes In-System Programmable Flash

Atmel Corporation 

ATtiny261A/461A/861A

1.1 Pin Descriptions

1.1.1 VCC

Supply voltage.

1.1.2 GND

Ground.

1.1.3 AVCC

Analog supply voltage. This is the supply voltage pin for the Analog-to-digital Converter (ADC),

the analog comparator, the Brown-Out Detector (BOD), the internal voltage reference and Port

A. It should be externally connected to VCC, even if some peripherals such as the ADC are not

used. If the ADC is used AVCC should be connected to VCC through a low-pass filter.

1.1.4 AGND

Analog ground.

1.1.5

Port A (PA7:PA0)

An 8-bit, bi-directional I/O port with internal pull-up resistors, individually selectable for each bit.

Output buffers have symmetrical drive characteristics with both high sink and source capability.

As inputs, port pins that are externally pulled low will source current if pull-up resistors have

been activated. Port pins are tri-stated when a reset condition becomes active, even if the clock

is not running.

Port A also serves the functions of various special features of the device, as listed on page 62.

1.1.6

Port B (PB7:PB0)

An 8-bit, bi-directional I/O port with internal pull-up resistors, individually selectable for each bit.

Output buffers have symmetrical drive characteristics with both high sink and source capability.

As inputs, port pins that are externally pulled low will source current if pull-up resistors have

been activated. Port pins are tri-stated when a reset condition becomes active, even if the clock

is not running.

Port B also serves the functions of various special features of the device, as listed on page 65.

1.1.7 RESET

Reset input. A low level on this pin for longer than the minimum pulse length will generate a

reset, even if the clock is not running and provided the reset pin has not been disabled. The min-

imum pulse length is given in Table 19-4 on page 188. Shorter pulses are not guaranteed to

generate a reset.

The reset pin can also be used as a (weak) I/O pin.

3

8197CS–AVR–05/11

Share Link: