CAT5132ZI-00-GT3 查看數據表（PDF） - Catalyst Semiconductor => Onsemi
零件编号
产品描述 (功能)
生产厂家
CAT5132ZI-00-GT3
Catalyst Semiconductor => Onsemi
CAT5132ZI-00-GT3 Datasheet PDF : 14 Pages
| |||
CAT5132
POTENTIOMETER OPERATION
Power-On
The CAT5132 is a 128-position, digital controlled
potentiometer. When applying power to the CAT5132,
VCC must be suplied prior to or simultaneously with V+.
At the sametime, the signals on RH, RW and RL terminals
should not exceed V+. If V+ is applied before VCC, The
electronic switches of the DPP are powered in the
absence of the switch control signals, that could result in
multiple switches being turned on. This causes
unexpected wiper settings and possible current overload
of the potentiometer. When VCC is applied the device
turns on at the mid-point wiper location (64) until the
wiper register can be loaded with the nonvolatile memory
location previously stored in the device. After the
nonvolatile memory data is loaded into the wiper register
the wiper location will change to the previously stored
wiper position.
At power-down, it is recommended to turn-off first the
signals on RH, RW and RL, followed by V+ and, after that,
VCC, in order to avoid unexpected transmistions of the
wipper and uncontrolled current overload of the
potentiometer.
The end-to-end nominal resistance of the potentiometer
has 128 contact points linearly distributed across the
total resistor. Each of these contact points is addressed
by the 7 bit wiper register which is decoded to select one
of these 128 contact points.
Each contact point generates a linear resistive value
between the 0 position and the 127 position. These
values can be determined by dividing the end-to-end
value of the potentiometer by 127. In the case of the
10kΩ potentiometer ~79Ω is the resistance between
each wiper position. However in addition to the ~79Ω for
each resistive segment of the potentiometer, a wiper
resistance offset must be considered. Table 8 shows the
effect of this value and how it would appear on the wiper
terminal.
This offset will appear in each of the CAT5132 end-to-
end resistance values in the same way as the 10kΩ
example. However resistance between each wiper
position for the 50kΩ version will be ~395Ω and for the
100kΩ version will be ~790Ω.
Table 8. Potentiometer Resistance and Wiper
Resistance Offset Effects
Position
00
01
63
127
Typical RW to RL Resistance for
10kΩ DPP
70Ω or
0Ω + 70Ω
149Ω or
79Ω + 70Ω
5,047Ω or
4,977Ω + 70Ω
10,070Ω or
10,000Ω + 70Ω
Position
00
64
126
127
Typical RW to RH Resistance for
10kΩ DPP
10,070Ω or
10,000Ω + 70Ω
5,047Ω or
4,977Ω + 70Ω
149Ω or
79Ω + 70Ω
70Ω or
0Ω + 70Ω
© Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
11
Doc No. MD-2124, Rev. E
Share Link: