CM1450-06CS 查看數據表（PDF） - California Micro Devices Corp
零件编号
产品描述 (功能)
生产厂家
CM1450-06CS Datasheet PDF : 8 Pages
| |||
PRELIMINARY
CM1450
Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
500
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS (NOTE 1)
SYMBOL
LTOT
L1, L2
CTOT
PARAMETER
Total Channel Inductance (L1 + L2)
Inductance
Total Channel Capcitance (C1⏐⏐C2 ⏐⏐ C3 )
C1, C2, C3 Capacitance
fC
fC
VDIODE
ILEAK
VSIG
VESD
VCL
Cut-off Frequency
ZSOURCE=50Ω, ZLOAD=50Ω
Roll-off Frequency at -10dB Attenuation
ZSOURCE=50Ω, ZLOAD=50Ω
Diode Standoff Voltage
Diode Leakage Current (reverse bias)
Signal Voltage
Positive Clamp
Negative Clamp
In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883,
Method 3015
b) Contact Discharge per IEC 61000-4-2
Level 4
Clamping Voltage during ESD Discharge
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
CONDITIONS
At 2.5V DC, 1MHz,
30mV AC
At 2.5V DC, 1MHz,
30mV AC
IDIODE=10µA
VDIODE=+3.3V
ILOAD = 10mA
Notes 2,4 and 5
Notes 2,3,4 and 5
MIN TYP
34
17
36 45
12 15
MAX
54
18
UNITS
nH
nH
pF
pF
137
300
5.5
100
5.6 6.8
9.0
-1.5 -0.8
-0.4
±30
±15
MHz
MHz
V
nA
V
V
kV
kV
+12
V
-7
V
Note 1: TA=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2005 California Micro Devices Corp. All rights reserved.
01/27/05 430 N. McCarthy Blvd., Milpitas, CA 95035-5112 ● Tel: 408.263.3214 ● Fax: 408.263.7846 ● www.calmicro.com 3
Share Link: 