CRG01 查看數據表（PDF） - Toshiba
零件编号
产品描述 (功能)
生产厂家
CRG01 Datasheet PDF : 4 Pages
| |||
Marking
Abbreviation Code
G1
G2
Part No.
CRG01
CRG02
CRG01,CRG02
Land pattern dimensions for reference only
1.2
1.2
2.8
Unit: mm
Handling Precaution
1) The absolute maximum ratings denote the absolute maximum ratings, which are rated values and must not be
exceeded during operation, even for an instant. The following are the general derating methods that we recommend
when you design a circuit with a device.
VRRM: We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the
absolute maximum rating of VRRM for a DC circuit and be no greater than 50% of that of VRRM for an AC
circuit. VRRM has a temperature coefficient of 0.1%/°C. Take this temperature coefficient into account
designing a device at low temperature.
IF (AV): We recommend that the worst case current be no greater than 80% of the absolute maximum rating of IF(AV).
Carry out adequate heat design. If you can’t design a circuit with excellent heat radiation, set the margin by
using an allowable Ta max - IF(AV) curve.
IFSM: This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.
Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the
device.
Tj: We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation
conditions.
2) Thermal resistance between junction and ambient fluctuates depending on the device’s mounting condition. When
using a device, design a circuit board and a soldering land size to match the appropriate thermal resistance value.
3) For other design considerations, see the Toshiba website.
2
2018-08-30
Share Link: 