DS1846 查看數據表（PDF） - Maxim Integrated
零件编号
产品描述 (功能)
生产厂家
DS1846 Datasheet PDF : 18 Pages
| |||
DS1846
MEMORY ORGANIZATION
The EEPROM of the DS1846 contains 256 bytes. Bytes 00h to F7h are general-purpose user memory.
The next three bytes, F8h, F9h, and FAh, contain the wiper settings for each of the potentiometers (see
Table 1). The last five bytes, FBh to FFh, are reserved and should not be used.
The memory, internal to the device, is organized as 32 pages of eight bytes each. Once an address byte is
clocked into the device through the 2-wire interface, the five MSBs decode which page is to be accessed,
and the three LSBs decode a particular byte on that page. The selected page is shadowed in SRAM as a
staging area while data is clocked in or out through the 2-wire interface. When reading any number of
bytes, all eight bytes of the current page are shadowed in SRAM where the requested byte(s) eventually
get clocked out. When reading, the page is incremented automatically, and hence transparent to the user.
When performing a write, the page of the starting address is shadowed in SRAM. The new data is then
written to the SRAM. When the end of the page is reached, the address returns to the beginning of the
same page. When the 2-wire master issues a stop, the entire page (even if only a single byte changed) is
copied from the SRAM into EEPROM. All reads and writes to the EEPROM are actually executed as
page operations even though they are invisible to the user when performing single byte reads and writes.
Understanding the internal memory organization is important when performing sequential address writes
due to page boundaries. See the Write Operations in the 2-WIRE OPERATION section for more
information.
MEMORY LOCATIONS Table 1
MEMORY NAME OF MEMORY
LOCATION
LOCATION
00h to F7h User Memory
FUNCTION OF MEMORY LOCATION
General-purpose user memory.
F8h
Potentiometer 1 Setting Writing to this byte controls the setting of potentiometer 1, a
256-position pot. Valid settings are 00h to FFh.
F9h
Potentiometer 0 Setting Writing to this byte controls the setting of potentiometer 0, a
100-position pot. Valid settings are 00h to 63h. MSB is ignored.
FAh
Potentiometer 2 Setting Writing to this byte controls the setting of potentiometer 0, a
100-position pot. Valid settings are 00h to 63h. MSB is ignored.
FBh to FFh Reserved
Reserved
4 of 18
Share Link: 