EL1503ACS-T7 查看數據表（PDF） - Intersil
零件编号
产品描述 (功能)
生产厂家
EL1503ACS-T7 Datasheet PDF : 2 Pages
| |||
®
PRODUCT BRIEF
Data Sheet
June 7, 2002
EL1503A
FN7039
High Power Differential Line Driver
The EL1503A ADSL Line Driver
contains two wideband high-voltage
drivers which are ideally suited for both
ADSL and HDSL2 applications. They can supply a 39.2VP-P
signal into a 22Ω load while exhibiting very low distortion.
The EL1503A also has a number of power saving features.
The IADJ pin can be used to set the maximum supply current
and the C0 and C1 pins can be used to digitally vary the
supply current to one of four modes. These modes include
full power, low power, terminate only and power down.
The EL1503A uses current-feedback type amplifiers, which
achieve a high slew rate while consuming moderate power.
They retain their frequency response over a wide range of
externally set gains. The EL1503A operates on ±5V to ±12V
supplies and consumes only 12.5mA per amplifier.
The device is supplied in a thermally-enhanced 20-pin SO
(0.300”), a thermally-enhanced 16-pin SO (0.150”), and the
small footprint (4x5mm) 24-pin LPP packages. Center pins
on each side of the 20-pin and 16-pin packages are used as
ground connections and heat spreaders. The LPP package
has the potential for a low θJA (<40°C/W) and dissipates
heat by means of a thermal pad that is soldered onto the
PCB. All package options are specified for operation over the
full -40°C to +85°C temperature range.
Get FULL DATASHEET
Features
• High power ADSL driver
• 39.2VP-P differential output drive into 22Ω
• 42.4VP-P differential output drive into 65Ω
• Driver 2nd/3rd harmonics of
-66dBc/-72dBc at 2VP-P into 100Ω differential
• Supply current of 12.5mA per amplifier
• Supply current control
• Power saving modes
• Standard surface-mount packages
• Ultra-small LPP package
Applications
• ADSL line drivers
• HDSL2 line drivers
• Video distribution amplifiers
Ordering Information
PART NUMBER
PACKAGE
TAPE &
REEL
EL1503ACM
20-Pin SO (0.300")
-
EL1503ACM-T13 20-Pin SO (0.300") 13”
EL1503ACL
24-Pin LPP
-
EL1503ACL-T7
24-Pin LPP
7”
EL1503ACL-T13
24-Pin LPP
13”
EL1503ACS
16-Pin SO (0.150”)
-
EL1503ACS-T7 16-Pin SO (0.150”) 7”
EL1503AC-T13 16-Pin SO (0.150”) 13”
PKG. NO.
MDP0027
MDP0027
MDP0046
MDP0046
MDP0046
MDP0027
MDP0027
MDP0027
1
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright © Intersil Americas Inc. 2002. All Rights Reserved. Elantec is a registered trademark of Elantec Semiconductor, Inc.
All other trademarks mentioned are the property of their respective owners.
Share Link: 