DS2433X 查看數據表（PDF） - Dallas Semiconductor -> Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

DS2433X

4 kbit 1-Wire EEPROM

Dallas Semiconductor -> Maxim Integrated 

HARDWARE CONFIGURATION Figure 8

DS2433

*5kΩ is adequate for reading the DS2433. To write to a single device, a 2.2kΩ resistor and VPUP of at

least 4.0V is sufficient. For writing multiple DS2433s simultaneously or operation at low VPUP, the

resistor should be bypassed by a low-impedance pullup to VPUP while the device copies the scratchpad to

EEPROM.

1-WIRE BUS SYSTEM

The 1-Wire bus is a system which has a single bus master and one or more slaves. In all instances the

DS2433 is a slave device. The bus master is typically a micro-controller. The discussion of this bus

system is broken down into three topics: hardware configuration, transaction sequence, and 1-Wire

signaling (signal types and timing). A 1-Wire protocol defines bus transactions in terms of the bus state

during specific time slots that are initiated on the falling edge of sync pulses from the bus master. For a

more detailed protocol description, refer to Chapter 4 of the Book of DS19xx iButton Standards.

HARDWARE CONFIGURATION

The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to

drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open

drain or 3-state outputs. The 1-Wire port of the DS2433 is open drain with an internal circuit equivalent

to that shown in Figure 8. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. At

regular speed the 1-Wire bus has a maximum data rate of 16.3k bits per second. The speed can be

boosted to 142k bits per second by activating the Overdrive Mode. The 1-Wire bus requires a pullup

resistor of approximately 5kΩ .

The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus

MUST be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low

for more than 16 µs (Overdrive Speed) or more than 120 µs (regular speed), one or more devices on the

bus may be reset.

TRANSACTION SEQUENCE

The protocol for accessing the DS2433 via the 1-Wire port is as follows:

§ Initialization

§ ROM Function Command

§ Memory Function Command

§ Transaction/Data

10 of 19

Share Link: