DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

FOD3120 查看數據表(PDF) - Fairchild Semiconductor

零件编号
产品描述 (功能)
生产厂家
FOD3120 Datasheet PDF : 22 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Switching Characteristics
Apply over all recommended conditions, typical value is measured at VCC = 30V, VEE = Ground, TA = 25°C
unless otherwise specified.
Symbol
Parameter
Conditions
tPHL
tPLH
PWD
PDD
(Skew)
tr
tf
tUVLO ON
tUVLO OFF
| CMH |
| CML |
Propagation Delay Time to Logic
Low Output
Propagation Delay Time to Logic
High Output
Pulse Width Distortion,
| tPHL – tPLH |
Propagation Delay Difference
Between Any Two Parts or
Channels, (tPHL – tPLH)(7)
Output Rise Time (10% – 90%)
Output Fall Time (90% – 10%)
UVLO Turn On Delay
UVLO Turn Off Delay
Common Mode Transient
Immunity at Output High
Common Mode Transient
Immunity at Output Low
IF = 7mA to 16mA,
Rg = 10, Cg =10nF,
f = 10kHz, Duty Cycle = 50%
IF = 10mA , VO > 5V
IF = 10mA , VO < 5V
TA = 25°C, VCC = 30V,
IF = 7 to 16mA, VCM = 2000V(8)
TA = 25°C, VCC = 30V, VF = 0V,
VCM = 2000V(9)
Min.
150
150
-250
35
35
Typ.
275
255
20
60
60
1.6
0.4
50
50
Max. Units
400
ns
400
ns
100
ns
250
ns
ns
ns
µs
µs
kV/µs
kV/µs
Notes:
1. Maximum pulse width = 10µs, maximum duty cycle = 1.1%
2. Derate linearly above 87°C, free air temperature at a rate of 0.77mW/°C
3. No derating required across temperature range.
4. Functional operation under these conditions is not implied. Permanent damage may occur if the device is
subjected to conditions outside these ratings.
5. Device is considered a two terminal device: Pins 2 and 3 are shorted together and Pins 5, 6, 7 and 8 are shorted
together.
6. 5,000 VRMS for 1 minute duration is equivalent to 6,000 VACRMS for 1 second duration.
7. The difference between tPHL and tPLH between any two FOD3120 parts under same test conditions.
8. Common mode transient immunity at output high is the maximum tolerable negative dVcm/dt on the trailing edge of
the common mode impulse signal, Vcm, to assure that the output will remain high (i.e. VO > 15.0V).
9. Common mode transient immunity at output low is the maximum tolerable positive dVcm/dt on the leading edge of
the common pulse signal, Vcm, to assure that the output will remain low (i.e. VO < 1.0V).
10. Pulse Width, PW 1µs, 300pps
11. Exponential Waveform, IO(PEAK) | 2.5A | (0.3µs)
©2003 Fairchild Semiconductor Corporation
FOD3120 Rev. 1.17.0
6
www.fairchildsemi.com

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]