FST3384MTC 查看數據表（PDF） - Fairchild Semiconductor
零件编号
产品描述 (功能)
生产厂家
FST3384MTC Datasheet PDF : 5 Pages
| |||
Absolute Maximum Ratings(Note 1)
Supply Voltage (VCC)
DC Switch Voltage (VS)
DC Input Voltage (VIN) (Note 2)
DC Input Diode Current (IIK) VIN<0V
DC Output (IOUT) Sink Current
DC VCC/GND Current (ICC/IGND)
Storage Temperature Range (TSTG)
−0.5V to +7.0V
−0.5V to +7.0V
−0.5V to +7.0V
−50 mA
128 mA
+/− 100mA
−65°C to +150°C
Recommended Operating
Conditions (Note 3)
Power Supply Operating (VCC)
Input Voltage (VIN)
Output Voltage (VOUT)
Input Rise and Fall Time (tr, tf)
Switch Control Input
4.0V to 5.5V
0V to 5.5V
0V to 5.5V
0nS/V to 5nS/V
Switch I/O
0nS/V to DC
Free Air Operating Temperature (TA)
−40°C to +85°C
Note 1: The “Absolute Maximum Ratings” are those values beyond which
the safety of the device cannot be guaranteed. The device should not be
operated at these limits. The parametric values defined in the “Electrical
Characteristics” table are not guaranteed at the absolute maximum ratings.
The “Recommended Operating Conditions” table will define the conditions
for actual device operation.
Note 2: The input and output negative voltage ratings may be exceeded if
the input and output diode current ratings are observed.
Note 3: Unused control inputs must be held HIGH or LOW. They may not
float.
DC Electrical Characteristics
Symbol
Parameter
VCC
(V)
TA = −40°C to +85°C
Min
Typ
(Note 4)
Max
Units
Condition
VIK
Clamp Diode Voltage
VIH
HIGH Level Input Voltage
VIL
LOW Level Input Voltage
II
Input Leakage Current
IOZ
OFF-STATE Leakage Current
RON
Switch On Resistance
(Note 5)
ICC
∆ ICC
Quiescent Supply Current
Increase in ICC per Input
4.5
4.0-5.5
2.0
4.0-5.5
5.5
5.5
4.5
4.5
4.5
4.0
5.5
5.5
Note 4: All typical values are at VCC = 5.0V, TA = 25°C.
−1.2
V IIN= − 18mA
V
0.8
V
±1.0
µA 0 ≤ VIN ≤ 5.5V
±1.0
µA 0 ≤ A, B ≤ VCC
4
7
Ω VIN = 0V, IIN = 64mA
4
7
Ω VIN = 0V, IIN = 30mA
8
15
Ω VIN = 2.4V, IIN = 15mA
11
20
Ω VIN = 2.4V, IIN = 15mA
3
µA VIN = VCC or GND, IOUT = 0
2.5
mA One input at 3.4V
Other inputs at VCC or GND
Note 5: Measured by voltage drop between A and B pin at indicated current through the switch. On resistance is determined by the lower of the voltages on
the two (A or B) pins.
www.fairchildsemi.com
2
Share Link: 