HCPL-0723-300 查看數據表（PDF） - HP => Agilent Technologies

零件编号

产品描述 (功能)

生产厂家

HCPL-0723-300

50 MBd 2 ns PWD High Speed CMOS Optocoupler

HP => Agilent Technologies 

All Agilent data sheets report the

creepage and clearance inherent

to the optocoupler component

itself. These dimensions are

needed as a starting point for the

equipment designer when

determining the circuit insulation

requirements. However, once

mounted on a printed circuit

board, minimum creepage and

clearance requirements must be

met as specified for individual

equipment standards. For

creepage, the shortest distance

path along the surface of a

printed circuit board between the

solder fillets of the input and

output leads must be considered.

There are recommended

techniques such as grooves and

ribs, which may be used on a

printed circuit board to achieve

desired creepage and clearances.

Creepage and clearance distances

will also change depending on

factors such as pollution degree

and insulation level.

IEC/EN/DIN EN 60747-5-2 Insulation Related Characteristics (Option 060)

Description

Symbol

HCPL-7723

Option 060

Installation classification per DIN VDE 0110/1.89, Table 1

for rated mains voltage ≤ 150 V rms

I-IV

for rated mains voltage ≤ 300 V rms

I-IV

for rated mains voltage ≤ 450 V rms

I-III

Climatic Classification

55/85/21

Pollution Degree (DIN VDE 0110/1.89)

2

Maximum Working Insulation Voltage

VIORM

630

Input to Output Test Voltage, Method b*

VPR

1181

VIORM x 1.875 = VPR, 100% Production Test with tm = 1 sec,

Partial Discharge < 5 pC

Input to Output Test Voltage, Method a*

VIORM x 1.5 = VPR, Type and Sample Test, tm = 60 sec,

Partial Discharge < 5 pC

VPR

945

Highest Allowable Overvoltage*

(Transient Overvoltage, tini = 10 sec)

VIOTM

6000

Safety Limiting Values (maximum values allowed in the

event of a failure, also see Thermal Derating curve,

Figure 11)

Case Temperature

Input Current

Output Power

Insulation Resistance at TS, VIO = 500 V

TS

175

IS,INPUT 230

PS,OUTPUT 600

RIO

≥ 109

HCPL-0723

Option 060 Units

I-IV

I-III

55/85/21

2

560

1050

V peak

V peak

840

V peak

4000

V peak

150

°C

150

mA

600

mW

≥ 109

Ω

*Refer to the front of the optocoupler section of the Isolation and Control Component Designer’s Catalog, under Product Safety Regulations section

IEC/EN/DIN EN 60747-5-2, for a detailed description.

Note: These optocouplers are suitable for “safe electrical isolation” only within the safety limit data. Maintenance of the safety data shall be

ensured by means of protective circuits.

Note: The surface mount classification is Class A in accordance with CECC 00802.

6

Share Link: