HCPL-0723-500E 查看數據表（PDF） - HP => Agilent Technologies
零件编号
产品描述 (功能)
生产厂家
HCPL-0723-500E Datasheet PDF : 12 Pages
| |||
Package Characteristics
All Typical Specifications are at TA = 25°C.
Parameter
Symbol Min. Typ. Max. Units Test Conditions
Input-Output Momentary
Withstand Voltage[7,8,9]
Input-Output Resistance[7]
–7723 VISO 3750
–0723
3750
R I-O
10 12
V rms
Ω
RH ≤ 50%, t = 1 min,
TA = 25°C
VI-O = 500 V dc
Input-Output Capacitance
Input Capacitance[10]
C I-O
0.6
pF
f = 1 MHz
CI
3.0
pF
Input IC Junction-to-Case
Thermal Resistance
–7723 θjci
–0723
Output IC Junction-to-Case –7723 θjco
Thermal Resistance
–0723
145
°C/W Thermocouple located at
160
center underside of package
145
°C/W
135
Package Power Dissipation
PPD
150 mW
Notes:
1. Absolute Maximum ambient operating temperature means the device will not be damaged if operated under these conditions. It does not
guarantee functionality.
2. The LED is ON when VI is low and OFF when VI is high.
3. tPHL propagation delay is measured from the 50% level on the falling edge of the VI signal to the 50% level of the falling edge of the VO signal.
tPLH propagation delay is measured from the 50% level on the rising edge of the VI signal to the 50% level of the rising edge of the VO signal.
4. PWD is defined as |tPHL - tPLH|. %PWD (percent pulse width distortion) is equal to the PWD divided by pulse width.
5. tPSK is equal to the magnitude of the worst case difference in tPHL and/or tPLH that will be seen between units at any given temperature within
the recommended operating conditions.
6. CMH is the maximum common mode voltage slew rate that can be sustained while maintaining VO > 0.8 VDD2. CML is the maximum common
mode voltage slew rate that can be sustained while maintaining VO < 0.8 V. The common mode voltage slew rates apply to both rising and
falling common mode voltage edges.
7. Device considered a two-terminal device: pins 1, 2, 3, and 4 shorted together and pins 5, 6, 7, and 8 shorted together.
8. In accordance with UL1577, each HCPL-0723 is proof tested by applying an insulation test voltage ≥ 4500 Vrms for 1 second (leakage detection
current limit, II-O ≤ 5 µA). Each HCPL-7723 is proof tested by applying an insulation test voltage ≥ 4500 Vrms for 1 second (leakage detection
current limit. II-O ≤ 5 µA.)
9. The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output continuous
voltage rating. For the continuous voltage rating refer to your equipment level safety specification or Agilent Application Note 1074 entitled
“Optocoupler Input-Output Endurance Voltage.”
10. CI is the capacitance measured at pin 2 (VI).
9
Share Link: 