HI-508 查看數據表（PDF） - Intersil
零件编号
产品描述 (功能)
生产厂家
HI-508 Datasheet PDF : 24 Pages
| |||
HI-506, HI-507, HI-508, HI-509
Absolute Maximum Ratings
V+ to V- . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .+44V
V+ to GND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .+22V
V- to GND. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -25V
Digital Input Voltage (VEN, VA) . . . . . (V-) -4V to (V+) +4V or 20mA,
Whichever Occurs First
Analog Signal (VIN, VOUT, Note 5) . . . . . . . . . . (V-) -2V to (V+) +2V
Continuous Current, In or Out . . . . . . . . . . . . . . . . . . . . . . . . . 20mA
Peak Current, In or Out (Pulsed 1ms, 10% Duty Cycle Max) . 40mA
Operating Conditions
Temperature Ranges
HI-50X-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-55°C to +125°C
HI-50X-4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-25°C to +85°C
HI-50X-5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0°C to +75°C
HI-50X-9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .-40°C to +85°C
Typical Minimum Supply Voltage . . . . . . . . . . . . ±10V or Single 20V
Thermal Information
Thermal Resistance (Typical, Note 4)
θJA (°C/W) θJC (°C/W)
16 Ld CERDIP Package. . . . . . . . . . . .
85
32
16 Ld SOIC Package . . . . . . . . . . . . . . 115
N/A
16 Ld PDIP Package . . . . . . . . . . . . . . 100
N/A
20 Ld PLCC Package. . . . . . . . . . . . . .
80
N/A
28 Ld CERDIP Package. . . . . . . . . . . .
55
18
28 Ld PDIP Package . . . . . . . . . . . . . .
60
N/A
28 Ld SOIC Package . . . . . . . . . . . . . .
70
N/A
28 Ld PLCC Package. . . . . . . . . . . . . .
70
N/A
Maximum Junction Temperature
Ceramic Packages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +175°C
Plastic Packages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +150°C
Maximum Storage Temperature Range . . . . . . . . . .-65°C to +150°C
Pb-free reflow profile . . . . . . . . . . . . . . . . . . . . . . . . . .see link below
http://www.intersil.com/pbfree/Pb-FreeReflow.asp
CAUTION: Do not operate at or near the maximum ratings listed for extended periods of time. Exposure to such conditions may adversely impact product reliability and
result in failures not covered by warranty.
NOTE:
4. θJA is measured with the component mounted on a low effective thermal conductivity test board in free air. See Tech Brief TB379 for details.
5. Signals on IN or OUT exceeding V+ or V- are clamped by internal diodes. Limit resulting current to maximum current ratings. If an overvoltage
condition is anticipated (analog input exceeds either power supply voltage), the Intersil HI-546/HI-547/HI-548/HI-549 multiplexers are
recommended.
Electrical Specifications Supplies = +15V, -15V; VAH (Logic Level High) = 2.4V; VAL (Logic Level Low) = 0.8V,
Unless Otherwise Specified. For Test Conditions, Consult Test Circuits Section
PARAMETER
DYNAMIC CHARACTERISTICS
Access Time, tA
-2
TEST
TEMP
MIN
CONDITIONS (°C) (Note 11) TYP
MAX
-4, -5, -9
MIN
(Note 11) TYP
25
-
250
500
-
250
Full
-
-
1000
-
-
Break-Before-Make Delay, tOPEN
Enable Delay (ON), tON(EN)
25
25
80
-
25
80
25
-
250
500
-
250
Full
-
-
1000
-
-
Enable Delay (OFF), tOFF(EN)
25
-
250
500
-
250
Full
-
-
1000
-
-
Settling Time, tS
(HI-506 and HI-507)
Settling Time, tS
(HI-508 and HI-509)
To 0.1%
To 0.01%
To 0.1%
To 0.01%
25
-
1.2
-
25
-
2.4
-
25
-
360
-
25
-
600
-
-
1.2
-
2.4
-
360
-
600
Off Isolation
Note 9
25
-
68
-
-
68
Channel Input Capacitance, CS(OFF)
Channel Output Capacitance, CD(OFF)
HI-506
25
-
10
-
-
10
25
-
52
-
-
52
HI-507
25
-
30
-
-
30
HI-508
25
-
17
-
-
17
HI-509
Digital Input Capacitance, CA
Input to Output Capacitance, CDS(OFF)
DIGITAL INPUT CHARACTERISTICS
25
-
12
-
-
12
25
-
6
-
-
6
25
-
0.08
-
-
0.08
Input Low Threshold, VAL
Input High Threshold, VAH
Full
-
-
0.8
-
-
Full
2.4
-
-
2.4
-
MAX
-
1000
-
-
1000
-
1000
-
-
-
-
-
-
-
-
-
-
-
-
0.8
-
UNITS
ns
ns
ns
ns
ns
ns
ns
μs
μs
ns
ns
dB
pF
pF
pF
pF
pF
pF
pF
V
V
8
FN3142.8
October 30, 2007
Share Link: 