HV6810PJ-G(2013) 查看數據表（PDF） - Supertex Inc
零件编号
产品描述 (功能)
生产厂家
HV6810PJ-G Datasheet PDF : 9 Pages
| |||
HV6810
DC Electrical Characteristics
(VDD = 5.0V, VBB = 60V, VSS = 0V, TA = 25OC unless otherwise noted)
Sym Parameter
VOH High level output voltage
Q outputs
Serial output
VOL
IOL
IO(OFF)
IIH
Low level output voltage
Q outputs
Serial output
Low level Q output current (pull-down current)
Off-state output current
High level input current
IDD Supply current from VDD (standby)
IBB Supply current from VBB
* All typical values are at TA = 25OC except for IOL and IO(OFF).
Min
57.5
4.0
-
-
60
-
-
-
-
-
-
Typ
58
4.5
0.15
0.05
80
-1.0
10
10
0.05
0.05
Max
-
-
1.0
0.1
-
-15
1.0
50
50
0.1
0.1
Units
V
V
µA
µA
µA
µA
mA
Conditions
IO = +25mA
VDD = +4.5V, IOL = +100µA
IO = -100µA,
blanking input at VDD
VDD = +4.5V, IO = -100µA
TA = Max, VOL = +0.7V
VO = 0V, blanking input at VDD
VlN = VDD
All inputs at 0V,
one Q output high
All inputs at 0V,
all Q outputs low
All outputs low,
all Q outputs open
All outputs high,
all Q outputs open
AC Electrical Characteristics
(Timing requirements over recommended operating conditions)
Sym Parameter
Min Typ Max Units Conditions
tW(CKH) Pulse duration, clock high
100 -
-
tW(LEH) Pulse duration, latch enable high
100 -
-
tSU(D) Setup time, data before clock
50 -
-
tH(D) Hold time, data after clock
50 -
-
tCKH-LEH Delay time, clock to latch enable high
50 -
-
tPD* Propagation delay time, latch enable to output - 300 -
* Switching characteristics, VBB = 60V, TA = 25OC
Power-up sequence should be the following:
1. Connect ground VSS
2. Apply VDD
3. Set all inputs (Data, CLK, Enable, etc.) to a known state
4. Apply VBB
The VBB should not drop below VDD or float during operation.
ns ---
ns ---
ns ---
ns ---
ns ---
ns ---
Power-down sequence should be the reverse of the above.
Doc.# DSFP-HV6810
E070913
Supertex inc.
3
www.supertex.com
Share Link: 