DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

IDT54FCT388915T100JB 查看數據表(PDF) - Integrated Device Technology

零件编号
产品描述 (功能)
生产厂家
IDT54FCT388915T100JB
IDT
Integrated Device Technology IDT
IDT54FCT388915T100JB Datasheet PDF : 11 Pages
1 2 3 4 5 6 7 8 9 10
IDT54/74FCT388915T 70/100/133/150
3.3V LOW SKEW PLL-BASED CMOS CLOCK DRIVER
MILITARY AND COMMERCIAL TEMPERATURE RANGES
NOTES:
7. The wiring diagrams and written explanations of Figure 3 demonstrate the input and output frequency relationships for various possible feedback
configurations. The allowable SYNC input range to stay in the phase-locked condition is also indicated. There are two allowable SYNC frequency ranges,
depending on whether FREQ_SEL is HIGH or LOW. Also it is possible to feed back the Q5 output, thus creating a 180° phase shift between the SYNC
input and the Q outputs. The table below summarizes the allowable SYNC frequency range for each possible configuration.
FREQ_SEL
Level
HIGH
HIGH
HIGH
HIGH
LOW
LOW
LOW
LOW
Feedback
Output
Q/2
Any Q (Q0-Q4)
Q5
2X_Q
Q/2
Any Q (Q0-Q4)
Q5
2X_Q
Allowable SYNC Input
Frequency Range (MHZ)
10 to (2x _Q fMAX Spec)/4
20 to (2x_Q fMAX Spec)/2
20 to (2x_Q fMAX Spec)/2
40 to (2x_Q fMAX Spec)
5 to (2x_Q fMAX Spec)/8
10 to (2x_Q fMAX Spec)/4
10 to (2x_Q fMAX Spec)/4
20 to (2x_Q fMAX Spec)/2
Corresponding 2Q Output
Frequency Range
40 to (2Q fMAX Spec)
40 to (2Q fMAX Spec)
40 to (2Q fMAX Spec)
40 to (2Q fMAX Spec)
20 to (2Q fMAX Spec)/2
20 to (2Q fMAX Spec)/2
20 to (2Q fMAX Spec)/2
20 to (2Q fMAX Spec)/2
Phase Relationship
of the Q Outputs
to Rising SYNC Edge
0°
0°
180°
0°
0°
0°
180°
0°
3052 tbl 09
8. The tPD spec describes how the phase offset between the SYNC input and the output connected to the FEEDBACK input, varies with process, temperature
and voltage. Measurements were made with a 10MHz SYNC input and Q/2 output as feedback. The phase measurements were made at 1.5V. The Q/
2 output was terminated at the FEEDBACK input with 100to VCC and 100to ground. tPD measurements were made with the loop filter connection
shown below:
External Loop
Filter
LF
0.1µF
C1
Analog GND 3052 drw 04
9.8
6

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]