IRS2093MPbF
Recommended Operating Conditions
For proper operation, the device should be used within the recommended conditions below. The Vs and
COM offset ratings are tested with supplies biased at VAA-VSS=10V, VCC=12V and VB-VS=12V. All voltage
parameters are absolute voltages referenced to COM; all currents are defined positive into any lead.
Symbol
Definition
Min.
Max.
Units
VBn
High side floating supply absolute voltage, n=1-4
VSn +10
VSn +14
V
VSn
High side floating supply offset voltage
†
200
V
IAAZ
Floating input positive supply zener clamp current
1
11
mA
ISSZ
Floating input negative supply zener clamp current
1
11
mA
VSS
Floating input supply absolute voltage
0
200
V
VHOn High side floating output voltage, n=1-4
Vs
VB
V
VCC, VCC2 Low side fixed supply voltage
10
15
V
VLOn
VGND
VIN-n
Low side output voltage, n=1-4
GND pin input voltage
Inverting input voltage, n=1-4
0
VSS†††
VCC2
V
VAA†††
V
VGND -0.5
VGND +0.5
V
VCSD CSD pin input voltage
VSS
VAA
V
VCOMPn COMP pin input voltage, n=1-4
VSS
VAA
V
CCOMPn
COMP pin phase compensation capacitor to GND,
n=1-4
1
-
nF
VDT
DT pin input voltage
0
IOREF
Reference output current to COM††
0.3
VOCSET OCSET pin input voltage
0.5
VCSHn CSH pin input voltage, n=1-4
VSn
dVss/dt Allowable Vss voltage slew rate upon power-up††††
-
VCC
V
0.8
mA
5
V
VBn
V
50
V/ms
fSW
Switching Frequency
TA
Ambient Temperature
-
800
kHz
-40
125
°C
†
††
†††
††††
Logic operational for Vsn equal to –5V to +200V. Logic state held for Vsn equal to –5V to –VBSn.
Nominal voltage for VREF is 5.1V. IOREF of 0.3 – 0.8mA dictates total external resistor value on VREF
to be 6.3k to 16.7k ohm.
GND input voltage is limited by IIN-n.
Vss ramps up from 0V to 200V.
www.irf.com
© 2009 International Rectifier
6