IS25C32B 查看數據表（PDF） - Integrated Silicon Solution

零件编号

产品描述 (功能)

生产厂家

IS25C32B

32K-BIT SPI AUTOMOTIVE EEPROM

Integrated Silicon Solution 

IS25C32B-Automotive

WRITE STATUS REGISTER (WRSR)

This instruction lets the user choose a Block Protection

setting, and set or reset the WPEN bit. The values of

the other data bits incorporated into WRSR can be 0

or 1, and are not stored in the Status Register. WRSR

will be ignored unless both the following are true: a)

WEN = 1, due to a prior WREN instruction; and b)

Hardware Write Protection is not enabled. (See Table

4 for details). Except for the RDY status, the values in

the Status Register remain unchanged until the mo-

ment when the write cycle is complete and the register

is updated. Note: WPEN can be changed from 1 to 0

only if WP is already set High. Once completed, WEN

is reset for complete chip write protection. (See Figure

5 for timing).

READ DATA (READ)

This instruction begins with the op-code and the 16-

bit address, and causes the selected data byte to be

shifted out on SO. Following this first data byte, addi-

tional sequential bytes are output. If the data byte in the

highest address is output, the address rolls-over to the

lowest address in the array, and the output could loop

indefinitely. At any time, a rising CS signal completes

the operation. (See Figure 6 for timing).

WRITE DATA (WRITE)

The WRITE instruction begins with the op-code, the

16-bit address of the first byte to be modified, and the

first data byte. Additional data bytes may be written se-

quentially to the array after the first byte. Each WRITE

instruction can affect the contents of a 32 byte page,

but no more. The page begins at address XXXXXXXX

XXX00000, and ends with XXXXXXXX XXX11111. If

the last byte of the page is input, the address rolls over

to the beginning of the same page. More than 32 data

bytes can be input during the same instruction, but upon

a completed write cycle, a page would only contain the

last 32 bytes.

The region of the array defined within Block Protection

cannot be modified as long as that block configuration

is selected. The region of the array outside the Block

Protection can only be modified if Write Enable (WEN)

is set to 1. Therefore, it may be necessary that a WREN

instruction occur prior to WRITE. Hardware Write Pro-

tection has no affect on the memory array. Once Write

is completed, WEN is reset for complete chip write

protection. (See Figure 7 for timing).

Table 5. Address Key

Name

IS25C32B

AN

Don't

Care Bits

A11-A0

A15-A12

Table 4. Write Protection

WPEN WP

Hardware Write WEN Inside Block Outside Block

Protection

0

X

Not Enabled

0

Read-only

Read-only

0

X

Not Enabled

1

Read-only

Unprotected

1

0

Enabled

0

Read-only

Read-only

1

0

Enabled

1

Read-only

Unprotected

X

1

Not Enabled

0

Read-only

Read-only

X

1

Not Enabled

1

Read-only

Unprotected

Note: X = Don't care bit.

Status Register

(WPEN, BP1, BP0)

Read-only

Unprotected

Read-only

Read-only

Read-only

Unprotected

6

Integrated Silicon Solution, Inc. — www.issi.com

Advanced Information  Rev.  00B

08/27/09

Share Link: