L6382D(2005) 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

L6382D
(Rev.:2005)

POWER MANAGEMENT UNIT FOR MICROCONTROLLED BALLAST

STMicroelectronics 

L6382D

Summarizing:

■ the high-voltage start-up generator is cycling;

■ VREF is enabled in low source current capability (IREF ≤ 10mA);

■ TPR circuit is disabled;

■ OCP is disabled;

■ the drivers are disabled.

If the Vcc voltage falls below the VREF(OFF) threshold, the device enters the start-up mode.

4.1.3 OPERATING Mode

After 10µs in save mode and only if the voltage at VREF is higher than 3.0V, on the falling edge on the

HGI input, the drivers are enabled as well as all the IC's functions; this is the mode correspondent to the

proper lamp behavior.

Summarizing:

■ HVSU is OFF

■ VREF is enabled in high source current mode (IREF < 30mA)

■ TPR circuit is enabled

■ OCP is enabled

■ the drivers are enabled

If there is no switching activity on LGI for more than 100µs, the IC returns in save mode.

4.1.4 Shut Down

This state permits to manage the fault conditions in operating mode and it is entered by the occurrence

on one of the following conditions:

– 1. Vcc<VccOff (Under Voltage fault on Supply),

– 2. VREF<2.0V (Under Voltage fault on VREF)

In this state the functions are:

■ The HVSU generator is ON

■ VREF is enabled in low source current mode (IREF < 10mA)

■ TPR is disabled

■ OCP is disabled

■ the drivers are disabled

In this state if Vcc reaches VccOn, the device enters the save mode otherwise, if Vcc<VREF(OFF), also the

µC is turned off and the device will be ready to execute the Start-up sequence.

Figure 6. Timing Sequences: TPR behavior (left) Start-up, save mode and operating mode (right).

Vcc

VCCon

TPR(O FF)

TPR(ON)

Vcc

VCCon

VccSM

VccOFF

TPR Switching

VREF

LGI

LGI

VREF

LGI

HGI

PSW

HVSU

10µs

OPERATING MODE

9/14

Share Link: