LC7367 查看數據表（PDF） - SANYO -> Panasonic
零件编号
产品描述 (功能)
生产厂家
LC7367 Datasheet PDF : 12 Pages
| |||
LC7367J, 7367JM
Key Operation
(1) Normal dial
Off-hook → D1 D2 · · · · Dn
Redial
Off-hook → RD
(2) PBX dial
Off-hook → D0 P D1 D2 · · · · Dn
Redial
Off-hook → RD
(3) Pulse/tone mix
¡ In case where there is no pause during mode select.
Off-hook → D1 D2 MC D3 D4 (P/T=H)
Redial
pulse
Tone
Off-hook → RD D1, D2 RD D3, D4
Puse
Tone
™ In case where there are pauses during mode select.
Off-hook → D1 D2 P MC D3 D4 (P/T=H)
Ridial
Off-hook →
pulse
Tone
4sec
RD D1, D2 – D3, D4
Puse
Tone
(Note)
a When in OUTPUT-PULSE mode P = X RD = #
b Pause : 4s. / 1 push of P , 8s. / 2 pushes of P , 4×ns. / n pushes of P
c For pause release, push RD . All pauses can be also released by pushing RD once.
Function Specifications
The LC7367J, 7367JM are capable of pulse dial, DTMF dial and also both types of dialing mixed, as well as redial of
these.
1) Dial Output Specifications
• The output pulse make ratio of OUT-PULSE mode can be set at 33.2 or 40% using the BMR pin.
• The output pulse rate of OUT-PULSE mode can be set at 20 or 10pps using the DPR pin.
• 12 types of DTMF dial signals (1 to 0, , #) are generated in DTMF mode.
• DTMF signals are output continuously when the keys are pressed.
• A minimum output for DTMF of approximately 100ms, and also about 100ms for minimum IDP are guaranteed.
2) Summary of Operation
• Key input data is written consecutively in the 31 digit buffer memory (also used as RD memory ; hereinafter
referred to as RD memory).
• The dial data in the RD memory is read out according to the set dial rate, and is output at the DP and DTMF pins.
• Dial output of more than 31 digits is enabled by rewriting the key data from the top (address 0) of the RD memory.
• Because of this, the correct dial does not remain in the RD memory for 32 digits or more, so redial for 32 digits or
more is prohibited.
• Dial data (1 to 0, , #), mode change data (MC) and pause data (P) are written in the RD memory as 1 digit each.
• Dial output mode switching can be performed using the MC key on the key matrix or the P/T input pin.
• The dial output can be stopped for 4 seconds with the pause key (P).
• One-touch redial can be done using the redial key (RD).
Continued on next page.
No.3095–8/12
Share Link: 