LT1224 查看數據表（PDF） - Linear Technology

零件编号

产品描述 (功能)

生产厂家

LT1224

Very High Speed Operational Amplifier

Linear Technology 

LT1224

APPLICATI S I FOR ATIO

The LT1224 may be inserted directly into HA2541, HA2544,

AD847, EL2020 and LM6361 applications, provided that

the nulling circuitry is removed. The suggested nulling

circuit for the LT1224 is shown below.

Offset Nulling

V+

5k

1

3+

8

76

LT1224

2–

4

V–

0.1µF

0.1µF

LT1224 • TA03

Layout and Passive Components

As with any high speed operational amplifier, care must be

taken in board layout in order to obtain maximum perfor-

mance. Key layout issues include: use of a ground plane,

minimization of stray capacitance at the input pins, short

lead lengths, RF-quality bypass capacitors located close

to the device (typically 0.01µF to 0.1µF), and use of low

ESR bypass capacitors for high drive current applications

(typically 1µF to 10µF tantalum). Sockets should be

avoided when maximum frequency performance is

required, although low profile sockets can provide

reasonable performance up to 50MHz. For more details

see Design Note 50. Feedback resistor values greater than

5k are not recommended because a pole is formed with the

input capacitance which can cause peaking. If feedback

resistors greater than 5k are used, a parallel

capacitor of 5pF to 10pF should be used to cancel the input

pole and optimize dynamic performance.

Transient Response

The LT1224 gain bandwidth is 45MHz when measured at

f = 1MHz. The actual frequency response in unity-gain is

considerably higher than 45MHz due to peaking caused by

a second pole beyond the unity-gain crossover. This is

reflected in the 50° phase margin and shows up as

overshoot in the unity-gain small-signal transient re-

sponse. Higher noise gain configurations exhibit less

overshoot as seen in the inverting gain of one response.

Small Signal, AV = 1

Small Signal, AV = –1

LT1224 • TA04

The large-signal responses in both inverting and non-

inverting gain show symmetrical slewing characteristics.

Normally the noninverting response has a much faster

rising edge than falling edge due to the rapid change in

input common-mode voltage which affects the tail current

of the input differential pair. Slew enhancement circuitry

has been added to the LT1224 so that the noninverting

slew rate response is balanced.

Large Signal, AV = 1

Large Signal, AV = –1

LT1224 • TA06

Input Considerations

Resistors in series with the inputs are recommended for

the LT1224 in applications where the differential input

voltage exceeds ±6V continuously or on a transient basis.

An example would be in noninverting configurations with

high input slew rates or when driving heavy capacitive

loads. The use of balanced source resistance at each input

is recommended for applications where DC accuracy must

be maximized.

6

Share Link: