DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

LT5517 查看數據表(PDF) - Linear Technology

零件编号
产品描述 (功能)
生产厂家
LT5517 Datasheet PDF : 12 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
LT5517
APPLICATIO S I FOR ATIO
The LT5517 is a direct I/Q demodulator targeting high
linearity receiver applications. It consists of an RF ampli-
fier, I/Q mixers, a quadrature LO carrier generator and bias
circuitry.
The RF signal is applied to the inputs of the RF amplifier,
and is then demodulated into I-channel and Q-channel
baseband signals using precision quadrature LO signals,
which are internally generated using a divide-by-two cir-
cuit. The demodulated I/Q signals are lowpass filtered
internally with a –3dB bandwidth of 130MHz. The differen-
tial outputs of the I-channel and Q-channel are well matched
in amplitude and their phases are 90° apart across the full
frequency range from 40MHz to 900MHz.
RF Input Port
Differential drive is recommended for the RF inputs as
shown in Figure 2. A low loss 1:4 transformer is used on
the demonstration board for a wide bandwidth input
impedance match and to assure good noise figure and
maximum demodulator gain. Single-ended to differential
conversion can also be implemented using narrowband
L-C circuits to produce the required balanced waveforms
at the RF+ and RFinputs using three discrete elements as
shown in Figure 5. Nominal values are listed in Table 1. (In
practice, these values should be compensated according
to the parasitics of the PCB.) The conversion gain and NF
of the receiver are similar to those of the transformer-
coupled demo board, because the single-ended to differ-
ential conversion has a 1:4 impedance transformation,
similar to the transformer.
Table 1. The Component Values of Matching Network LSH, CS1
and CS2
FREQUENCY (MHz)
LSH (nH)
CS1, CS2 (pF)
40
437
71.1
100
169
28.6
200
80.8
14.3
300
51.5
9.6
400
37
7.2
500
28.3
5.8
600
22.6
4.9
700
18.5
4.2
800
15.6
3.7
900
13.5
3.3
The differential impedance of the RF inputs is listed in
Table 2. The RF inputs may also be terminated in a single-
ended configuration. In this case either the RF+ or the RF
input can be simply AC coupled to a 50source, while the
other RF input is connected to ground with a 1nF capacitor.
Note, however, that this will result in degraded conversion
gain and noise figure in most cases.
RF
INPUT
MATCHING NETWORK
CS1
3.7pF
CS2
3.7pF
LSH
15.6nH
5517 F05
TO RF+
TO RF
Figure 5. RF Input Matching Network at 800MHz
5517f
8

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]