LTC2053I(RevB) 查看數據表（PDF） - Linear Technology

零件编号

产品描述 (功能)

生产厂家

LTC2053I
(Rev.:RevB)

Precision, Rail-to-Rail, Zero-Drift, Resistor-Programmable Instrumentation Amplifier

Linear Technology 

LTC2053/LTC2053-SYNC

PI FU CTIO S

EN (Pin 1, LTC2053 Only): Active Low Enable Pin.

CLK (Pin 1, LTC2053-SYNC Only): Clock input for

synchronizing to external system clock.

–IN (Pin 2): Inverting Input.

+IN (Pin 3): Noninverting Input.

V– (Pin 4): Negative Supply.

REF (Pin 5): Voltage Reference (VREF) for Amplifier Output.

RG (Pin 6): Inverting Input of Internal Op Amp. With a

resistor, R2, connected between the OUT pin and the RG

pin and a resistor, R1, between the RG pin and the REF pin,

the DC gain is given by 1 + R2 / R1.

OUT (Pin 7): Amplifier Output.

VOUT = GAIN (V+IN – V–IN) + VREF

V+ (Pin 8): Positive Supply.

BLOCK DIAGRA

+IN

3

–IN

2

8

V+

ZERO-DRIFT

+ OP AMP

CS

CH

OUT 7

–

REF RG V– EN/CLK*

5

6

4

1

2053 BD

*NOTE: PIN 1 IS EN ON THE LTC2053 AND CLK ON THE LTC2053-SYNC.

APPLICATIO S I FOR ATIO

Theory of Operation

The LTC2053 uses an internal capacitor (CS) to sample a

differential input signal riding on a DC common mode

voltage (see Block Diagram). This capacitor’s charge is

transferred to a second internal hold capacitor (CH) trans-

lating the common mode of the input differential signal to

that of the REF pin. The resulting signal is amplified by a

zero-drift op amp in the noninverting configuration. The

RG pin is the negative input of this op amp and allows

external programmability of the DC gain. Simple filtering

can be realized by using an external capacitor across the

feedback resistor.

Input Voltage Range

The input common mode voltage range of the LTC2053 is

rail-to-rail. However, the following equation limits the size

of the differential input voltage:

V– ≤ (V+IN – V–IN) + VREF ≤ V+ – 1.3

Where V+IN and V–IN are the voltages of the +IN and –IN

pins respectively, VREF is the voltage at the REF pin and V+

is the positive supply voltage.

For example, with a 3V single supply and a 0V to 100mV

differential input voltage, VREF must be between 0V and

1.6V.

±5 Volt Operation

When using the LTC2053 with supplies over 5.5V, care

must be taken to limit the maximum difference between

any of the input pins (+IN or –IN) and the REF pin to 5.5V;

if not, the device will be damaged. For example, if rail-to-

rail input operation is desired when the supplies are at

±5V, the REF pin should be 0V, ±0.5V. As a second

example, if V+ is 10V and V– and REF are at 0V, the inputs

should not exceed 5.5V.

2053syncfb

9

Share Link: