LTC6605-7
PIN FUNCTIONS
+IN4 A, –IN4 A, +IN4 B, –IN4 B (Pins 1, 5, 7, 11): Inputs
to Trimmed 400Ω Resistors. Can accept an input signal,
be floated, tied to an output pin, or connected to external
components.
+IN1 A, –IN1 A, +IN1 B, –IN1 B (Pins 2, 4, 8, 10): Inputs
to Trimmed 100Ω Resistors. Can accept an input signal,
be floated, tied to an output pin, or connected to external
components.
BIAS A, BIAS B (Pins 3, 9): Three-State Input to Select
Amplifier Power Consumption. Drive low for shutdown,
drive high for full power, leave floating for medium power.
BIAS presents an input resistance of approximately 150k
to a voltage 1.15V above V–.
V– (Pins 6, 14, 17, 20): Negative Supply. All V– pins
should be connected to the same voltage, either a ground
plane or a negative supply rail.
VOCMA, VOCMB (Pins 19, 13): The voltage applied to these
pins sets the output common mode voltage of each filter
channel. If left floating, VOCM self-biases to a voltage
midway between V+ and V–.
V+ A, V+ B (Pins 21, 15): Positive Supply for Filter Channel
A and B, Respectively. These are not connected to each
other internally.
–OUT A, +OUT A, –OUT B, +OUT B (Pins 22, 18, 16, 12):
Differential Output Pins.
Exposed Pad (Pin 23): Always tie the underlying Exposed
Pad to V–. If split supplies are used, do not tie the pad
to ground.
66057f
8