DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

LTC6915IDE 查看數據表(PDF) - Linear Technology

零件编号
产品描述 (功能)
生产厂家
LTC6915IDE Datasheet PDF : 18 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
LTC6915
Electrical Characteristics The l denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at TA = 25°C.
Timing, V+ = 4.5V to 5.5V, V= 0V (Note 7)
t1
DIN Valid to CLK Setup
t2
DIN Valid to CLK Hold
l 30
ns
l0
ns
t3
CLK Low
l 50
ns
t4
CLK High
t5
CS/LD Pulse Width
t6
LSB CLK to CS/LD
t7
CS/LD Low to CLK
t8
DOUT Output Delay
CL = 15pF
l 50
l 40
l 40
l 20
l
ns
ns
ns
ns
85
ns
t9
CLK Low to CS/LD Low
l0
ns
Timing, Dual ±4.5V to ±5.5V Supplies (Note 7)
t1
DIN Valid to CLK Setup
t2
DIN Valid to CLK Hold
t3
CLK High
t4
CLK Low
l 30
ns
l0
ns
l 50
ns
l 50
ns
t5
CS/LD Pulse Width
l 40
ns
t6
LSB CLK to CS/LD
t7
CS/LD Low to CLK
t8
DOUT Output Delay
t9
CLK Low to CS/LD Low
CL = 15pF
l 40
l 20
l
l0
ns
ns
85
ns
ns
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: These parameters are tested at ±5V supply; at 3V and 5V supplies
they are guaranteed by design.
Note 3: These parameters are guaranteed by design. Thermocouple effects
preclude measurement of these voltage levels in high speed automatic test
systems. VOS is measured to a limit set by test equipment capability.
Note 4: If the total source resistance is less than 10k, no DC errors result
from the input bias current or mismatch of the input bias currents or the
mismatch of the resistances connected to INand IN+.
Note 5: The PSRR measurement accuracy depends on the proximity of
the power supply bypass capacitor to the device under test. Because of
this, the PSRR is 100% tested to relaxed limits at final test. However, their
values are guaranteed by design to meet the data sheet limits.
Note 6: Supply current is dependent on the clock frequency. A higher clock
frequency results in higher supply current.
Note 7: Guaranteed by design, not subject to test.
6915fb
6

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]