DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

M48Z08(2010) 查看數據表(PDF) - STMicroelectronics

零件编号
产品描述 (功能)
生产厂家
M48Z08
(Rev.:2010)
ST-Microelectronics
STMicroelectronics ST-Microelectronics
M48Z08 Datasheet PDF : 20 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
M48Z08, M48Z18
2
Operation modes
Operation modes
Note:
2.1
The M48Z08/18 also has its own power-fail detect circuit. The control circuitry constantly
monitors the single 5 V supply for an out of tolerance condition. When VCC is out of
tolerance, the circuit write protects the SRAM, providing a high degree of data security in the
midst of unpredictable system operation brought on by low VCC. As VCC falls below
approximately 3 V, the control circuitry connects the battery which maintains data until valid
power returns.
Table 2. Operating modes
Mode
VCC
E
G
W
Deselect
WRITE
READ
4.75 to 5.5 V
or
4.5 to 5.5 V
VIH
X
X
VIL
X
VIL
VIL
VIL
VIH
READ
VIL
VIH
VIH
Deselect VSO to VPFD(min)(1)
X
X
X
Deselect
VSO(1)
X
X
X
1. See Table 10 on page 15 for details.
X = VIH or VIL; VSO = Battery backup switchover voltage.
DQ0-DQ7
Power
High Z
DIN
DOUT
High Z
Standby
Active
Active
Active
High Z
High Z
CMOS standby
Battery backup mode
READ mode
The M48Z08/18 is in the READ mode whenever W (WRITE enable) is high and E (chip
enable) is low. The device architecture allows ripple-through access of data from eight of
65,536 locations in the static storage array. Thus, the unique address specified by the 13
address inputs defines which one of the 8,192 bytes of data is to be accessed. Valid data
will be available at the data I/O pins within address access time (tAVQV) after the last
address input signal is stable, providing that the E and G access times are also satisfied. If
the E and G access times are not met, valid data will be available after the latter of the chip
enable access time (tELQV) or output enable access time (tGLQV).
The state of the eight three-state data I/O signals is controlled by E and G. If the outputs are
activated before tAVQV, the data lines will be driven to an indeterminate state until tAVQV. If
the address inputs are changed while E and G remain active, output data will remain valid
for output data hold time (tAXQX) but will go indeterminate until the next address access.
Doc ID 2424 Rev 7
7/20

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]