M5482B7 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M5482B7

LED DISPLAY DRIVER

STMicroelectronics 

M5482

Figure 4. Input Data Format

CLOCK

DATA

LOAD

(INTERNAL)

RESET

(INTERNAL)

1

START BIT 1

36

BIT 34 BIT 35

At the low state of the clock a RESET signal is

generated which clears all the shift registers for

the next set of data. The shift registers are static

master slave configurations. There is no clear for

the master portion of the first shift register, thus al-

lowing continuous operation.

There must be a complete set of 36 clocks or the

shift registers will not clear.

When power is first applied to the chip an internal

power ON reset signal is generated which resets

all registers and all latches. The START bit and the

first clock return the chip to its normal operation.

Figure 5 shows the timing relationships between

Data and Clock.

A maximum clock frequency of 0.5 MHz is as-

sumed.

Table 3 shows the Output Data Format for the

M5482. Because it uses only 15 of the possible 35

outputs, 20 of the bits are "Don’t Cares".

For applications where a lesser number of outputs

are used it is possible to either increase the cur-

rent per output or operate the part at higher than

1V VOUT.

The following equation can be used for calcula-

tions.

Tj … [(VOUT)(ILED)(no.of segments) + VDD . 7 mA]

(80 °C/W) + Tamb

where:

Tj ≡ junction temperature (150 °C max)

VOUT = the voltage at the LED driver outputs

ILED = the LED current

80 °C/W = thermal coefficient of the package

Tamb = ambient temperature

Figure 5.

CLOCK

DATA

300ns (min.)

Table 3. Serial Data Bus / Outputs Correspondence

5451 35 34 33 32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 START

5482 15 X X X X 14 13 X X X X 12 11 10 9 X X X START

5451 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 START

5482 X 8 7 6 5 X X X X 4 3 2 1 X X X X START

4/10

Share Link: