M65665 查看數據表（PDF） - MITSUBISHI ELECTRIC

零件编号

产品描述 (功能)

生产厂家

M65665

PICTURE-IN-PICTURE SIGNAL PROCESSING

MITSUBISHI ELECTRIC  

MITSUBISHI DIGITAL TV ICs

M65665SP/FP

PICTURE-IN-PICTURE SIGNAL PROCESSING

The relation of input signal 32-pin (Main-HD) and 33-pin (Main-VD) is shown below

32-pin

input

(Main-HD)

33-pin input

(Main-VD)

-10usec

[Even to Odd]

33-pin input

(Main-VD)

[Odd to Even]

0

+10usec

+21.75usec

prohibition time of

changing 33-pin signal

+41.75usec

+53.5usec

20us

20us

20us

20us

20us

20us

VD input

4H

1H

end of vertical equalization pulse

37.5us

20us

20us

20us

20us

20us

20us

VD input

Driv ing Method and Operating Specif ication f or Serial Interf ace Data

(1) Serial data transmission completion and start

A low-to-high transition of the DATA (serial data) line while the CLK (serial clock) is high, that completes the serial transmission and makes the

bus free.

A high-to-low transition of the DATA line while the CLK is high, that starts the serial transmission and waits for the following CLK and DATA

inputs.

(2) Serial data transmission

The data are transmitted in the most significant bit (MSB) first by one-byte unit on the DATA line successively. One-byte data transmission is

completed by 9 clock cycles, the former 8 cycles are for address/data and the latter one is for acknowledge detection. (In reading state, ACK is 'H'

under these two conditions ; 1) the coincidence of two address data for the address data transmission, 2) the completion of 8-bit setting data

transfer. In writing state, ACK is 'H' with the address coincidence and ACK is 'L' for detecting acknowledge input from the master (micro

processor) after sending 8-bit setting data.)

For address/data transmission, DATA must change while CLK is 'L'. (The data change while CLK is 'H' or the simultaneous change of CLK and

DATA, that will be a false operation because of undistinguished condition from the completion/start of serial data transfer).

After the beginning of serial data transmission, the total number of data bytes that can be transferred are not limited.

(3) The byte format of data transmission (The sequence of data transmission)

a. The byte format during data setting to M65665FP are shown as follows.

In right after the forming of serial data transmitting state, the slave address 24h (00100100b) is transferred. Afterwards, the internal register

address (1 byte) and setting data (by 1 byte unit) are transferred successively. Several bytes of setting data can be handled in the one

transmission. In this operation, the setting data are written into the address register whose address is increased one in initially transferred internal

register address.

b. The byte format during data reading from M65665FP are shown as follows.

Before data reading from M65665FP, whose internal address need to be set by the data reading/transmitting. After the data reading/transmitting,

the operation of "serial data transmission completion and start" (described in (1)) is necessary. Continuously, the slave address 25h (00100101b)

is sent, and then the inverted read out data are available on ACK. Several bytes of writing data can be handled in the one transmission, too. In this

operation, the setting data also are written into the address register whose address is increased one in initially transferred internal register address.

MITSUBISHI

10

ELECTRIC

Share Link: