M95160-X 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

M95160-X

16 Kbit and 8 Kbit serial SPI bus EEPROM with high speed clock

STMicroelectronics 

Operating features

4

Operating features

M95160-x, M95080-x

4.1

4.1.1

4.1.2

4.1.3

Supply voltage (VCC)

Operating supply voltage VCC

Prior to selecting the memory and issuing instructions to it, a valid and stable VCC voltage

within the specified [VCC(min), VCC(max)] range must be applied (see Table 9, Table 10 and

Table 11). This voltage must remain stable and valid until the end of the transmission of the

instruction and, for a Write instruction, until the completion of the internal write cycle (tW). In

order to secure a stable DC supply voltage, it is recommended to decouple the VCC line with

a suitable capacitor (usually of the order of 10 nF to 100 nF) close to the VCC/VSS package

pins.

Device reset

In order to prevent inadvertent write operations during power-up, a power-on-reset (POR)

circuit is included. At power-up, the device does not respond to any instruction until VCC

reaches the POR threshold voltage (this threshold is defined in DC characteristics tables 15,

16, 17, 18, 19 and 20 as VRES).

When VCC passes over the POR threshold, the device is reset and is in the following state:

● in Standby Power mode

● deselected (note that, to be executed, an instruction must be preceded by a falling

edge on Chip Select (S))

● Status Register value:

– the Write Enable Latch (WEL) is reset to 0

– Write In Progress (WIP) is reset to 0

– The SRWD, BP1 and BP0 bits remain unchanged (non-volatile bits)

When VCC passes over the POR threshold, the device is reset and enters the Standby

Power mode. The device must not be accessed until VCC reaches a valid and stable VCC

voltage within the specified [VCC(min), VCC(max)] range defined in Table 9, Table 10 and

Table 11.

Power-up conditions

When the power supply is turned on, VCC rises continuously from VSS to VCC. During this

time, the Chip Select (S) line is not allowed to float but should follow the VCC voltage. It is

therefore recommended to connect the S line to VCC via a suitable pull-up resistor (see

Figure 4).

In addition, the Chip Select (S) input offers a built-in safety feature, as the S input is edge

sensitive as well as level sensitive: after power-up, the device does not become selected

until a falling edge has first been detected on Chip Select (S). This ensures that Chip Select

(S) must have been high, prior to going low to start the first operation.

The VCC voltage has to rise continuously from 0 V up to the minimum VCC operating voltage

defined in Table 9, Table 10 and Table 11 and the rise time must not vary faster than 1 V/µs.

12/50

Doc ID 8028 Rev 10

Share Link: