MAX4545C/D 查看數據表（PDF） - Maxim Integrated

零件编号

产品描述 (功能)

生产厂家

MAX4545C/D

Quad/Dual, Low-Voltage, Bidirectional RF/Video Switches

Maxim Integrated 

Quad/Dual, Low-Voltage,

Bidirectional RF/Video Switches

LOGIC

IN

50Ω

IN/OUT

V+

10nF

12

V+

1 IN1

IN2 16

82Ω

(194Ω)

2 COM1

3 GND1

4 NO1

6 NC4

MAX4546

COM2 15

14

GND2

NO2 13

NC3 11

50Ω

OUT/IN

38Ω

(61Ω)

7 GND4

8 COM4

V-

10nF 5

GND3 10

COM3 9

38Ω

(61Ω)

V-

LOGIC

0

1

SWITCH

OFF

ON

SWITCHES SHOWN FOR LOGIC “0” INPUT

( ) ARE FOR 75 SYSTEMS.

Figure 2. Impedance Matching On/Off Switch

On the MAX4545, GND5 and GND6 should always be

connected to the ground plane with solid copper to

improve isolation and crosstalk.

Signal Routing

Keep all signal leads as short as possible. Separate all

signal leads from each other and other traces with the

ground plane on both sides of the board. Where possi-

ble, use coaxial cable instead of printed circuit board

traces.

Board Layout

IC sockets degrade high-frequency performance and

should not be used if signal bandwidth exceeds 5MHz.

Surface-mount parts, having shorter internal lead

frames, provide the best high-frequency performance.

Keep all bypass capacitors close to the device, and

separate all signal leads with ground planes. Such

grounds tend to be wedge-shaped as they get closer to

the device. Use vias to connect the ground planes on

each side of the board, and place the vias in the apex of

the wedge-shaped grounds that separate signal leads.

Logic-level signal lead placement is not critical.

Impedance Matching

The typical on-resistances of the switches in the

MAX4545/MAX4546/MAX4547 are 14Ω, but the off-

state impedances are approximately equal to a 6pF

capacitor. In coaxial systems, therefore, it is impossible

to match any impedance for both the on and off state. If

impedance matching is critical, the MAX4546 is best

suited, since its two sections can be configured as a

single on/off switch, as shown in Figure 2. This circuit

“wastes” switches and has higher losses, but has bet-

ter off isolation and maintains good impedance match-

ing in both the on and off states. The resistance values

shown in Figure 3 are optimized with ±5V supplies for

both 50Ω and 75Ω systems at room temperature.

Multiplexer

With its excellent off isolation, the MAX4545 is ideal for

use in high-frequency video multiplexers. Figure 3

shows such an application for switching any one of four

video inputs to a single output. The same circuit may

be used as a demultiplexer by simply reversing the sig-

nal direction.

Stray capacitance of traces and the output capacitance

of switches placed in parallel reduces bandwidth, so the

outputs of no more than four individual switches should

be placed in parallel if high bandwidth is to be main-

tained. If more than four mux channels are needed, the

4-channel circuit should be duplicated and cascaded.

______________________________________________________________________________________ 11

Share Link: