MB89817A 查看數據表（PDF） - Fujitsu

零件编号

产品描述 (功能)

生产厂家

MB89817A

(MB89850 / MB89860 Series) 8-bit Proprietary Microcontroller

Fujitsu 

MB89810A Series

s HANDLING DEVICES

1. Preventing Latchup

Latchup may occur on CMOS ICs if voltage higher than VCC or lower than VSS is applied to input and output pins

other than medium- to high-voltage pins or if higher than the voltage which shows on “1. Absolute Maximum

Ratings” in section “s Electrical Characteristics” is applied between VCC and VSS.

When latchup occurs, power supply current increases rapidly and might thermally damage elements. When

using, take great care not to exceed the absolute maximum ratings.

2. Treatment of Unused Input Pins

Leaving unused input pins open could cause malfunctions. They should be connected to a pull-up or pull-down

resistor.

3. Power Supply Voltage Fluctuations

Although VCC power supply voltage is assured to operate within the rated range, a rapid fluctuation of the voltage

could cause malfunctions, even if it occurs within the rated range. Stabilizing voltage supplied to the IC is therefore

important. As stabilization guidelines, it is recommended to control power so that VCC ripple fluctuations (P-P

value) will be less than 10% of the standard VCC value at the commercial frequency (50 to 60 Hz) and the transient

fluctuation rate will be less than 0.1 V/ms at the time of a momentary fluctuation such as when power is switched.

4. Precautions when Using an External Clock

Even when an external clock is used, oscillation stabilization time is required for power-on reset (optional) and

wake-up from stop mode.

8

Share Link: