MB90350E 查看數據表（PDF） - Fujitsu

零件编号

产品描述 (功能)

生产厂家

MB90350E

16-bit Microcontrollers

Fujitsu 

MB90350E Series

• Sub clock pin (X0A, X1A)

• Yes (using the external oscillation) : devices without S-suffix

• No (using the sub clock mode at internal CR oscillation) : devices with S-suffix

• Timer

• Timebase timer, watch timer, watchdog timer : 1 channel

• 8/16-bit PPG timer : 8-bit × 10 channels or 16-bit × 6 channels

• 16-bit reload timer : 2 channels (only Evaluation products has 4 channels)

• 16- bit input/output timer

- 16-bit free-run timer : 2 channels (FRT0 : ICU0/1, FRT1 : ICU4/5/6/7, OCU4/5/6/7)

- 16- bit input capture: (ICU) : 6 channels

- 16-bit output compare : (OCU) : 4 channels

• FULL-CAN interface : 1 channel

• Compliant with CAN standard Version2.0 Part A and Part B

• 16 message buffers are built-in

• CAN wake-up function

• LIN-UART : 2 channels

• Equipped with full-duplex double buffer

• Clock-asynchronous or clock-synchronous serial transmission is available.

• I2C interface : 1 channel

Up to 400 kbps transfer rate

• DTP/External interrupt : 8 channels, CAN wakeup : 1 channel

Module for activation of extended intelligent I/O service (EI2OS), DMA, and generation of external interrupt by

external input.

• Delay interrupt generator module

Generates interrupt request for task switching.

• 8/10-bit A/D converter : 15 channels

• Resolution is selectable between 8-bit and 10-bit.

• Activation by external trigger input is allowed.

• Conversion time : 3 µs (at 24 MHz machine clock, including sampling time)

• Address matching detection (Program patch) function

• Address matching detection for 6 address pointers.

• Capable of changing input voltage level for port

• Automotive/CMOS-Schmitt (initial level is Automotive in single chip mode)

• TTL level (corresponds to external bus pins only, initial level of these pins is TTL in external bus mode)

• Low voltage/CPU operation detection reset (devices with T-suffix)

• Detects low voltage (4.0 V ± 0.3 V) and resets automatically

• Resets automatically when program is runaway and counter is not cleared within interval time

(approx. 262 ms : external 4 MHz)

• Dual operation Flash memory (only devices 128 Kbytes Flash memory)

• Erase/write and read can be executed in the different bank (Upper Bank/Lower Bank) at the same time.

• Supported TA = + 125 °C

The maximum operating frequency is 24 MHz* : (at TA = +125 °C) .

(Continued)

DS07-13744-4E

3

Share Link: